Operation Manual

1/29/2008 VoIP Phone Administration Guide

MAG-07010 Rev. C

3 Setup the VoIP Phone via a Web Browser

Default the IP Phone’s Bridge is enabled, WAN port is in DHCP Client Mode. LAN port is the same as WAN.

Connect the IP Phone to DHCP server, and the server will assign an IP address to the phone. Check the IP

address and add the port number “:9999” at the end of the IP address to access the web browser.

Note: When selecting DHCP Client and cannot detecting the IP, the IP Phone will provide a default IP,

192.168.2.25.

Note: It is highly recommended to use Internet Explorer 6.0 for web configurations.

3.1 Login

Please input the username and password into the blank field. The default setting is:

1. For the Administrator, the username is: admin; and the password is: smcadmin . If you use the account login,

you can configure the setting.

2. For a normal user, the username is: user; and the password is: test. If you use the account login, but you

can not configure the SIP setting.

Click Login to move into the VOIP PHONE web based management information page.

Any changes in the Web Management interface except for Phone Book require clicking Submit in that page, and

then go to the Save Change page and click Save. The system will restart, and all the settings can work properly.

Note: The GUI will automatically log out after 5 minutes, if you do not do any action.

3.2 System Information for the IP PHONE

When you login to the web page, you can see the current system information of the IP phone, like Firmware

Version and Vendor ID in this page.

Also you can see the function lists in the left side. You can use mouse to click the function you want to set up.