Operation Manual

1/29/2008 VoIP Phone Administration Guide
MAG-07010 Rev. C
20
Router, or Broadband Router. Also, you can use PPPoE to get the WAN IP address from your ISP.
The default setting is Bridge mode. If you don’t need to use the Bridge mode, you can change to NAT mode.
The WAN port default is DHCP Client mode. You can change the setting to Fixed IP mode, or PPPoE mode.
If you change the WAN port’s setting to Fix IP mode, then you have to make sure the IP address, Net Mask,
Gateway, and DNS setting are suitable in your current network environment.
If you change the WAN port’s setting to PPPoE mode, you have to input a correct username/password to get the
IP address from your Internet Service Provider.
When you have finished the settings, click Submit. Go to the Save Change page and click Save to reflect the
changes.
Note: When selecting DHCP Client and cannot detecting the IP, the IP Phone will provide a default IP,
192.168.2.25.
3.5.3 LAN Settings
In this page, you can configure the IP Phone LAN port’s setting.