Instruction Manual

ManualsBrandsSmeg ManualsAppliances4 piece Stainless Steel Kitchen Appliances Package

USER INSTRUCTIONS

f fo gnihct iwS 8.2.2

eh t dna peeb t r ohs a s t ime r ehsawhs i d eh t ,ma r go r p eh t f o dne eh t t A indi-

cator lights of the fourth and ﬁ fth program (ref. pr. 4, pr. 5 ﬁ g. 2-04) ﬂ ash.

Turn off the appliance by opening the door and pressing the on/off button (ref.

1 ﬁ g. 2-02).

FIG. 2-04

If it is necessary to open the door during the washing cycle, the

program will be interrupted, the relative indicator light will continue to

ﬂ ash and a beep will indicate that the cycle has not terminated. Wait

for about 1 minute before closing the door and continuing with the

program. When the door closes, the program will start from where it

was interrupted. This operation should be performed only if neces-

sary as it could cause irregular program performance.

SEHS I D EHT G N I V OM E R 4

˜˜˜

t sae l t a t i aw ,m a r go r p gn i hsaw eh t f o dne eh t t A 20 minute before

removing the dishes in order to allow them to cool. To prevent any

water droplets on the upper rack from falling onto the dishes in the

lower rack, empty the lower rack ﬁ rst and then the upper one.

2.2.9

symbols programs according to the models

2.3 Additional functions

2.3.1 Adjusting the water softener (on some models only)

N.B.: a different washing program from soak must be used to make

the following adjustment.

Press and hold down the program delay button (ref. 12 ﬁ g. 2-05) until the

preset value appears followed by a dot (normally 3.). Release the button and

then press it again and again until the required value is displayed, as indicated

in the table (see tab. 2-03).

The 6 possible adjustment levels will appear in this sequence:

3., 4., 5., 0., 1., 2..

When the required value appears on the display, release the button; after 5

seconds the appliance automatically reverts to the program delay and the

adjustment is set to the chosen value.

2.3.1 ADJUSTING THE WATER SOFTENING SYSTEM

The dishwasher is equipped with a device which allows the softener setting to be

varied to suit the hardness of the mains water. The hardness is set using the PRO-

GRAM SELECTION BUTTON (3).

To access the setting function, hold the button down for more than 15 seconds.

The WATER HARDNESS ADJUSTMENT INDICATOR LIGHT (4) ashes, while the SE-

LECTED PROGRAM INDICATOR LIGHTS (2) show the current setting. Each pressure

on the button changes the setting following the sequence in the table below:

WATER HARDNESS TABLE

WATER HARDNESS

SETTING

German de-

grees (°dH)

French

Degrees (°dF)

0 - 6 0 - 11

All lights o

(no salt)

7 - 10 12 - 18 One light on

11 - 15 19 - 27 Two lights on

16 - 21 28 - 37 Three lights on

22 - 28 38 - 50 Four lights on

29 - 35 51 - 62 Five lights on

36 - 50 63 - 90 Two lights on

Contact your local water board for information on the hardness of your water sup-

ply.

After adjustment or display of the current setting, simply do not touch the button

for a few seconds; the dishwasher will automatically return to standard mode, quit-

ting the adjustment mode.