Use and Care

Instructions for the user

9.4 Oven door glass

The oven door glass should always be kept clean. Use absorbent kitchen paper towel to clean. In case

of tough spots, clean with a damp sponge using a standard household detergent.

NOTE: Do not use abrasive or corrosive cleaners to clean the oven door glass (e.g. powders, spray-on

oven cleaners, stain removers or steel wool pads).

Do not use rough or abrasive materials or sharp metal scrapers to clean the oven door glass as they can

scratch the surface or cause the glass to break.

9.5 Automatic cleaning cycle

Automatic cleaning cycle may be carried out at any time of the day or night (if you wish to benefit from

the lower cost of electricity overnight).

During the first automatic cleaning cycle, unpleasant odours may occur due to the normal evaporation of

oily manufacturing substances. This is an absolutely normal phenomenon which disappears after the

first cleaning cycle.

Before starting the automatic cleaning cycle, make sure that the oven does not contain any foods or

large spills from previous cooking operations.

During the automatic cleaning cycle, a door locking device makes it impossible to open the door. In case

you would like to interrupt the oven-cleaning function (pyrolysis) before it has finished, when the function

has just been turned on, the waiting time for the release of the door is approximately 10 minutes. When

the oven is hot, the waiting time for the release of the door is approximately 30 minutes.

9.5.1 Before starting the automatic cleaning cycle

• Completely remove all accessories from inside the oven.

• Remove the guide frames, see “9.3.1 Removing guide frames”.

In order not to damage the internal glass panel, it should be cleaned in accordance with the usual

procedure before starting the automatic cleaning cycle.

For very stubborn encrustations spray an oven cleaning product onto the glass (read the warnings on

the product); leave for 60 minutes, then rinse and dry the glass using kitchen roll or a microfiber cloth.

• Remove the guide frames, see “9.3.1 Removing guide frames”.

• At the end of the cleaning cycle, when the oven has cooled down, reinsert the frames by repeating

the previously used procedure in reverse order.

• Make sure that the oven door is firmly closed.

Refer to the following diagram for setting the cleaning cycle duration (add approximately 40 minutes of

waiting time for the door to release at the end of the function):

CLEANING

LIGHT DIRT MEDIUM DIRT HEAVY DIRT

DURATION 120 MIN. 165 MIN. 210 MIN.

During the automatic cleaning cycle, the fans produce a more intense level of noise due to a greater

rotation speed; this is entirely normal and intended to facilitate heat dissipation.

At the end of pyrolysis, the fans will continue to operate for long enough to avoid overheating the walls of

adjacent units and the front of the oven.