Instruction manual

Installation
21
ITEN
Gas cylinder compartment
• The opening and interior of the
compartment must correspond to the
dimensions of the largest cylinders (fitted
with regulator) and must be of
dimensions such as to allow easy
introduction and removal of the cylinder.
• It must be easy to insert and remove the
cylinder complete with regulator.
• The compartment must ensure sufficient
ventilation from the apertures both at the
base and the upper part.
• The cylinder compartment ventilation
openings must not be obstructed.
• The cylinder compartment must not
communicate directly with the parts of the
appliance where the burners are
installed.
• The cylinder support must not deform
when loaded with a full cylinder.
Cylinders must not be placed directly on
the floor.
• The cylinder connection point and cock
must be easily accessible.
• Spills from recipients placed on the hob
must not fall directly on the cylinder or its
accessories.
• The hose must not come into contact with
sharp edges.
Cylinder positioning
Example of cylinder positioned to side
Example of cylinder positioned to rear
Example of cylinder positioned under non-
flammable panel