Instruction manual

Installation
43
EN
Access to the terminal board
To connect the power supply cable, you
must access the terminal board on the rear
casing:
1. Remove the screws fastening the plate to
the rear casing.
2. Gently rotate the plate and remove it
from its seat.
3. Proceed with installation of the power
supply cable.
4. When you have finished, reposition the
plate on the rear casing and fasten it in
place with the previously removed
screws.
Fixed connection
Install an all-pole disconnection device in
the power line that ensures full
disconnection from the mains supply and
which has a contact opening distance that
provides full disconnection under
overvoltage category III conditions, in
accordance with the wiring regulations. The
circuit breaker should be located near the
appliance and in an easily reachable
position.
It is recommended to slacken off
the cable clamp screw before
installing the power supply cable.