Range Instructions for Installation and Use

Instructions for the Installer
80
12.2 Removing the door
Open the door completely and insert the pins (supplied) into the holes from
the inside. Close the door to an angle of about 45° and lift it off. To
reassemble, fit the hinges into their grooves, then lower the door into place
and extract the pins.
12.3 Oven door gaskets
To allow thorough cleaning of the oven, the door
gaskets can be removed. Before removing the
gaskets, remove the oven doors as described above.
Once the doors have been removed, lift the tangs at
the corners as shown on the right.
12.4 Greasing the gas taps
Over time, the gas taps may become stiff or jam. Clean their insides and
change their lubricating grease. This operation must be carried out by
a skilled technician.