Range Instructions for Installation and Use
Table Of Contents
- 1. INSTRUCTIONS FOR PROPER USE
- 2. SAFETY INSTRUCTIONS
- 3. KNOW YOUR HOB
- 4. BEFORE FIRST USE
- 5. COOKING ZONES
- 6. DESCRIPTION OF CONTROL ON THE FRONT CONTROL PANEL
- 7. USE OF THE COOKING HOB
- 7.1 Hobs with knobs
- 7.2 Hobs with touch-control buttons
- 7.2.1 Switching on the hob
- 7.2.2 Single cooking zones
- 7.2.3 Dual cooking zones
- 7.2.4 Triple cooking zones
- 7.2.5 Heating zone
- 7.2.6 Cooking zone lock-out
- 7.2.7 Cooking zone layout
- 7.2.8 Timer (on some models only)
- 7.2.9 Modifying the data set
- 7.2.10 Residual heat
- 7.2.11 Control circuit board thermal protection
- 7.2.12 Operator Error
- 7.2.13 Switching off the cooking zones
- 7.2.14 Switching off
- 7.3 Cooking tips
- 7.4 Holding function “A”
- 8. CLEANING AND MAINTENANCE
- 9. SOMETHING WRONG?
- 10. INSTALLATION
Instructions for the installer
29
10. INSTALLATION
10.1 Technical information
Hob type See rating plate
Electrical connections
220-240V~ 50/60Hz / 380-415V 2N∼ 50/60Hz / 380-415V 3N∼ 50/60Hz
HOB RATING
Electric
Maximum electrical power See rating plate
DIMENSIONS OF THE HOB
Width (mm) 290 595 720 900
Depth (mm) 510 510 510 510
10.2 The rating plate
Make sure that the voltage and capacity of the power
line conform to the data shown on the plate located
under the casing. Do not remove this plate for any
reason..
10.3 Electrical connection
IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED ACCORDING TO THE
METHODS REQUIRED BY SAFETY RULES.
WHEN LINKING UP TO MAINS BY PLUG AND SOCKET, MAKE SURE THAT BOTH ARE
COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE COMPLYING WITH
APPLICABLE REGULATIONS.
THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN BUILT IN.
NEVER UNPLUG BY PULLING ON THE CABLE.
IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE HOB,
FOLLOWING THE INSTRUCTIONS. IF THE HOB FAILS TO OPERATE, AFTER CHECKING THAT
YOU HAVE CARRIED OUT THE INSTRUCTIONS CORRECTLY, DISCONNECT THE APPLIANCE
FROM THE ELECTRICAL MAINS AND CONTACT YOUR NEAREST SERVICE CENTRE.
NEVER ATTEMPT TO REPAIR THE APPLIANCE.
IF A PLUG AND SOCKET CONNECTION IS BEING USED MAKE SURE THAT THE PLUG AND
SOCKET ARE COMPATIBLE. AVOID USE OF ADAPTERS AND SHUNTS AS THESE COULD
CAUSE OVERHEATING AND RISK OF BURNS.
IF A FIXED CONNECTION IS BEING USED FIT POWER LINE WITH AN OMNIPOLAR CIRCUIT
BREAKER WITH A CONTACT OPENING GAP EQUAL TO OR GREATER THAN 3 MM IN AN
EASILY ACCESSIBLE POSITION IN PROXIMITY TO THE HOB.
Serial
N°
MODEL