User manual

EN - 8
minute.
If 5 blue stripes appear on the strip, select
“light water” settings.
If 1 or 2 pink stripes appear on the strip, select
“average water” settings.
If 3, 4 or 5 pink stripes appear on the strip,
select “hard water” settings.
• To open the water hardness settings,
simultaneously press and hold down keys
(16) and (20) for at least 3
seconds, LEDs (21) , (22) , (23)
will ash simultaneously.
• Choose the water hardness, referring to the
following table, pressing the key (16)
, the LED relating to the selected hardness
lights up steadily, the others go off .
Led Hardness
21
Light
22
Medium
23
Hard
• To memorize the selected hardness,
press keys (16) and (20)
simultaneously for at least 3 seconds or do
not press any key for 15 seconds .
To prolong the machine operation
and preserve the aroma and taste of
the coffee, it is recommended to use
the Smeg Softener Filter (optional,
not supplied). For installation and
operation, follow the instructions
that accompany the accessory.
Once installed, set the water
hardness level to ‘Light’ following
the instructions in the previous
paragraph.
Cleaning and maintenance
CLEANING AND MAINTENANCE
(Fig. C-E-F-G-H-I-L)
Incorrect use Risk of damage to
surfaces.
• Do not use steam jets to clean
the coffee machine.
• Do not use cleaning products
containing chlorine, ammonia
or bleach on parts with metal
surface nishes (e.g. anodised,
nickel- or chrome-plated).
• Do not use abrasive or corrosive
detergents (e.g. powder
products, stain removers and
metallic scourers).
• Do not use rough or abrasive
materials or sharp metal
scrapers.
Manual rinse
• Make sure that the White program is
selected with keys (16), (17), (18), (19)
illuminated in white.
• With the machine ready to dispense and
the drip tray mounted, press the keys (20)
and (19) simultaneously for at
least 3 seconds: the machine will rinse the
coffee circuit (coffee dispenser 11).
• At the end of the washing cycle, the keys
light up steadily.
Cleaning of the machine body
For a good preservation of the external
surfaces it is necessary to clean them regularly
at the end of each use, after letting them cool.
Clean with a soft cloth dampened with water.
Never immerse the machine body
(1) in water or other liquids.