EN User Manual Fridge Freezer C176DN2PA
CONTENTS Safety information Safety instructions Operation Daily use Hints and tips 2 3 5 8 10 Care and cleaning Troubleshooting Installation Technical data 11 12 15 16 Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage.
• • • • • • • Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. Do not damage the refrigerant circuit. Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents.
• Make sure not to cause damage to the electrical components (e.g. mains plug, mains cable, compressor). Contact the Authorised Service Centre or an electrician to change the electrical components. • The mains cable must stay below the level of the mains plug. • Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.
OPERATION Control Panel 1 8 1 2 3 4 5 6 7 Display Freezer Temperature warmer button Freezer Temperature colder button OK Mode Fridge Temperature warmer button 6 5 4 3 2 7 Fridge Temperature colder button 8 ON/OFF It is possible to change predefined sound of buttons by pressing together Mode and temperature colder button for a few seconds. Change is reversible. Display A B C D E F G Off min L K J I H Switching on 1. Connect the mains plug to the power socket. 2.
Switching off 1. Press the appliance ON/OFF for 5 seconds. The display switches off. 2. Disconnect the mains plug from the power socket. Temperature regulation Set the temperature of the appliance by pressing the temperature regulators. Default set temperature: • +5°C for the fridge • -18°C for the freezer The temperature indicators show the set temperature. The set temperature will be reached within 24 hours. After a power failure the set temperature remains stored.
The function switches off by selecting a different set temperature. FastFreeze function The FastFreeze function accelerates the freezing of fresh food and, at the same time, protects foodstuffs already stored from undesirable warming. 1. To activate this function press the Mode button until the corresponding icon appears. The FastFreeze indicator flashes. 2. Press the OK button to confirm. TheFastFreeze indicator is shown. This function stops automatically after 52 hours.
DAILY USE WARNING! Refer to Safety chapters. Cleaning the interior Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand-new product, then dried thoroughly. CAUTION! Do not use detergents, abrasive powders, chlorine or oil-based cleaners as they will damage the finish. Do not move the glass shelf above the vegetable drawer to ensure correct air circulation.
Storage of frozen food When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings. WARNING! In the event of accidental defrosting, for example due to a power failure, if the power has been off for longer than the value shown in the technical characteristics chart under "rising time", the defrosted food must be consumed quickly or cooked immediately and then re-frozen (after cooling).
the indicated storage time is valid depends on the quality of the foods and treating before freezing. HINTS AND TIPS Normal operating sounds The following sounds are normal during operation: • A faint gurgling and bubbling sound from coils sound when refrigerant is pumped. • A whirring and pulsating sound from the compressor when refrigerant is pumped. • A sudden cracking noise from inside appliance caused by thermic dilatation (a natural and not dangerous physical phenomenon).
compartment, can possibly cause the skin to be freeze burnt; • it is advisable to show the freezing in date on each individual pack to enable you to keep tab of the storage time.
Defrosting the freezer The freezer compartment is frost free. This means that there is no build up of frost when it is in operation, neither on the internal walls nor on the foods. 2. Remove all food. 3. Clean the appliance and all accessories. 4. Leave the door/doors open to prevent unpleasant smells. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: 1. Disconnect the appliance from electricity supply.
Problem Possible cause Solution A square symbol is shown instead of numbers on the Temperature Display. Temperature sensor problem. Contact the nearest Authorised Service Centre (the cooling system will continue to keep food products cold, but temperature adjustment will not be possible). The lamp does not work. The lamp is in stand-by. Close and open the door. The lamp does not work. The lamp is defective. Contact the nearest Authorised Service Centre. The compressor operates continually.
Problem Possible cause Solution The compressor does not start immediately after pressing the Shopping, or after changing the temperature. This is normal, no error has occurred. The compressor starts after a period of time. Water flows on the rear plate of the refrigerator. During the automatic defrosting process, frost melts on the rear plate. This is correct. Water flows inside the refrigerator. The water outlet is clogged. Clean the water outlet.
If the advice does not lead to the desired result, contact the nearest Authorised Service Centre. Replacing the lamp The appliance is equipped with a longlife LED interior light. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to assembly instructions. 3. If necessary, replace the defective door gaskets. Contact the Authorised Service Centre. Only service is allowed to replace the lighting device. Contact your Authorised Service Centre.
Ventilation requirements CAUTION! Refer to the assembly instructions for the installation. The airflow behind the appliance must be sufficient. 5 cm min. 200 cm2 min. 200 cm2 TECHNICAL DATA Technical data Dimensions of the recess Height mm 1780 Width mm 560 Depth mm 550 Rising time Hours 23 Voltage Volts 230-240 Frequency Hz 50 The technical information is situated in the rating plate, on the external or internal side of the appliance and in the energy label.
222373555-A-462016