User manual

Problem Possible cause Solution
Water flows inside the refrig‐
erator.
Food products prevent the
water to flow into the wa‐
ter collector.
Make sure that food products
do not touch the rear plate.
The water outlet is clog‐
ged.
Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
Attach the melting water outlet
to the evaporative tray.
Temperature cannot be set. The "FastFreeze function"
is switched on.
Switch off "FastFreeze func‐
tion" manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function".
The temperature in the ap‐
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera‐
ture.
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The food products' tem‐
perature is too high.
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Many food products are
stored at the same time.
Add less food products at the
same time.
The thickness of the frost
is greater than 4-5 mm.
Defrost the appliance.
The door has been
opened often.
Open the door only if necessa‐
ry.
The "FastFreeze function"
is switched on.
Refer to "FastFreeze function".
There is no cold air circu‐
lation in the appliance.
Make sure that there is cold
air circulation in the appliance.
All the temperature setting
LEDs flash at the same
time.
An error has occurred in
measuring the tempera‐
ture.
Contact the nearest Author‐
ised Service Centre. The cool‐
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible.
13