Installation and Operation Guide

ManualsBrandsSmeg ManualsAll Stoves70cm Classic Aesthetic Freestanding Gas Oven/Stove

Instructions for the installer

12.4.3Adjusting the gas oven burner minimum setting

1 Light the oven burner and keep it at the maximum for 10/15 minutes.

2 Then turn the knob to the minimum temperature.

3 Extract the gas tap knob and turn the adjustment screw next to the tap rod

(depending on the model) until the correct minimum flame is achieved.

4 Refit the knob and verify that the burner flame is stable (when turning the

knob rapidly from the maximum to the minimum position the flame must not

go out). This procedure must be carried out while the door is closed.

5 (Only for adjustment different from LPG) Open and close the door, if the flame

goes out the minimum must be increased.

If using LPG, the adjustment screw must be tightened to end of stroke. If using natural or city gas, simply

unscrew the adjustment screw by a few turns.

12.5 Burner and nozzle characteristics table

Burner

ULPG - 2.75

kPa

Nominal gas

consumption

(MJ/h)

Injector

(1/100

mm)

Auxiliary

3.9

.54

Semi-rapid

6.3

.68

Ultra-rapid (Wok)

15.0

1.05

Oven

11.5

.94