Instruction manual

Use
80
Only for some zones: the Booster function
is always enabled and has to be disabled
manually using the corresponding knob.
Power control
The hob is fitted with a power control
module that optimises/limits consumption. If
the overall set power level exceeds the
maximum limit permitted, the electronic
circuit board will automatically manage the
power supplied by the hot plates.
The module tries to maintain the maximum
deliverable power levels. Levels set by the
automatic control will appear on the
display.
The flashing of a power level indicates that
it will be automatically limited to a new level
selected by the power control module.
Hob power limitation
1. Disconnect the appliance from the mains
power supply and wait 10 seconds
before turning the power back on.
2. Turn the front left and front right cooking
zone knobs anticlockwise at the same
time (to position “M-A” and “A”
respectively), and keep them in this
position for 3 seconds.
The rear left and rear right cooking zone
displays will indicate “7.” and “4”.
3. Release the knobs.
4. Turn and hold both knobs anti-clockwise
again.
The rear left and rear right cooking zone
displays will indicate the power levels “4.”
and “8”.
5. Release the knobs.
6. Turn and hold both knobs anti-clockwise
again.
The rear left and rear right cooking zone
displays will indicate the power levels “3.”
and “7”.
The Booster function has priority
over the heating accelerator
function.
Priority is given to the last zone set.
The induction hob is configured to
operate at 7.4 kW, but it can be
set to operate at 4.8 kW or 3.7
kW.
The power level of the hob must be
set within 2 minutes of it being
connected to the mains power
supply.