GB Instructions for use Upright refrigerator-freezer
Upright refrigerator-freezer Thank you for your confidence in buying our appliance and congratulations on the excellent choice. We hope it will successfully serve its purpose for many years. Upright refrigerator - freezer (hereinafter: the appliance) consists of two parts: top part is refrigerator and bottom part is upright freezer. Refrigerator is used in households for storage of fresh food at temperatures above 0°C.
Before first operation 181300 • The appliance is manufactured in compliance with all relevant safety standards; however, it is recommended that persons with impaired physical, motional, or mental abilities, or persons with inadequate experience and knowledge, do not use the appliance without due supervision. The same recommendation applies to minors using the appliance. • Before connecting the appliance read these instructions carefully.
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of thisproduct.
Description of the appliance Interior equipment of the appliance will typically vary according to the specific model.
Installation and connections Selecting the location Positioning the appliance • Place the appliance in dry and well aired room. The appliance operates best at temperature ranges indicated in the chart below. Relevant class of the appliance is indicated on the rating plate.
• The appliance is fitted with spacers to be mounted on the top edge of the condenser. They prevent the rear of the appliance to be pushed too close to the wall. Spacers are fabricated universally regarding the different distance of the condenser from the cabinet, so make sure to position them properly. • Use the power cord to connect the appliance to the mains power. Wall outlet must be fitted with ground terminal (safety socket).
Changing the Direction of Opening the Door Freestanding appliance Necessary tools: ring spanner No.8, screwdriver, torque 25 Tilt the appliance so that the bottom hinge can be unscrewed and proceed with disassembling as shown in the Figure 3. Then fix the assembly parts again in the opposite turn. Use the attached opposite hinge insert piece. Use the bungs, which have been pulled out, on the opposite side. Check the door seal. In case that it does not rest well, take it off and turn it by 180°.
Control panel - appliance with electronical regulation CONTROL UNIT I CONTROL UNIT II No frost system appliance A Digital temperature display (certain models only) of the refrigerator indicates actual temperatures during the operation from +1°C to +9°C. B ON/OFF and temperature setting button C Orange LED: illuminated during fan operation (knob D).
Refrigerator temperature setting • • • • • (control panel I) Start of fan assisted cooling Temperature of the appliance is set by turning the button (B) to the position between the Min and Max span. Recommended setting of the thermostat knob is to ECO position. If the room temperature, in which the appliance is installed, is lower than 16°C, the recommended setting of the thermostat knob is to the Max.
• To repeat the fast freeze function you need to first turn the knob (B) from the SF/SC position to the position Eco, and then back to the position SF/SC! Open refrigerator door alarm (control panel I) The alarm sounds if the refrigerator door is left open for more than 1 minute. When the door is closed again the alarm stops. CONTROL UNIT III Valve and no frost system appliance A Freezer temperature setting button B Freezer temperature digital display: indicates temperature span between -16°C and -24°C.
Temperature setting • • • • Other settings Refrigerator temperature setting span +1°C do +9°C Freezer temperature setting span -16°C to -24°C + fast freeze Freezer temperature is set by the button (A), and refrigerator temperature by the button (N). When you press one of temperature setting buttons, the digital display starts flashing and indicates the last selected temperature. Temperature setting is changed by short sequence pressing of the button in steps of 1°C.
Intermittent sound signal – power failure alarm If the refrigerator or freezer temperature increases excessively due to power failure, this is signaled by the sound alarm (intermittent beep), red light is on, and the display indicates flashing maximum temperature digit (max. 9°C for the refrigerator). Fast cooling of the refrigerator The function of fast cooling of the refrigerator interior is activated by pressing the button (K) – orange LED is on (L).
Control panel - Appliance with mechanical regulation ON/OFF button The appliance is switched on/off by turning the temperature selector (see Fig.) to any position from 0 to 7. The appliance operation is controlled by turning the thermostat (temperature selecting button) located within the refrigerator cabinet from the position STOP (0) to the position 7 and back.
• Crisp tray below the glass shelf at the bottom of the refrigerator is used for storage of fruit and vegetables. It retains the right level of moisture and prevents drying out. Single drawer • Pulling out the drawer: - Pull the drawer towards yourself (in the direction of arrow 1) – as far as the door stopper. On the opposite side, continue to pull the drawer out of the refrigerator (in the direction of arrow 2 – rotation) while lifting the drawer at the same time (in the direction of arrow 3).
Refrigerator door lining compartments: - top/middle section: eggs, butter, cheese, … - bottom section: beverages, cans, bottles, … Freezer compartments: - freezing, storage of frozen food (see section Freezing and storage of frozen food). Storage of food in the refrigerator Important precautions and hints • Proper use of the appliance, adequately packed food, correct temperature and hygienic precautions produce substantial impact on the quality of stored food.
Storage of food in the FRESH ZONE The FRESH ZONE drawer provides storage of wide selection of fresh food longer than in the traditional refrigerator. Food remains fresh for long time and it preserves its taste and nutritive ingredients. It reduces decay and loss of mass, so fruit and vegetables are more fresh and natural. The drawer must be tightly closed to provide optimum operation.
Freezing and storage of frozen food Storage procedure • Activate the fast freeze function by pressing the button (C) for continuous operation 24 hours prior intended freezing. - control unit 1 and 2: with knob B, position SF/SC; - control unit 3: with key C; - mechanical regulation: knob position approximately between 4 and 6. Upon expiry of this period insert fresh food in the freezing compartment. Do not let the already frozen packages touch the fresh ones.
Storage of industrially frozen food The storage time and recommended temperature for storing commercially frozen foods is indicated on the packaging. Always follow manufacturer’s instructions for storage and use of frozen food. When shopping be careful to choose only food which is adequately packed and provided with complete data and stored in freezers where the temperature never rises above -18°C. Do not buy packages of food wrapped with frost.
Defrosting the appliance Automatic defrosting of the refrigerator Refrigerator needs no special defrosting procedure, because ice deposited at the inner back wall is defrosted automatically. Ice deposited on the inner back wall during the compressor operation is defrosted when the compressor stops operating, and condensed water drops are drained through the outlet in the inner back wall into the drain pan situated above the compressor where it evaporates.
Cleaning the appliance Prior any cleaning attempt disconnect the appliance from the mains (see the control chapter for ON/OFF function), and pull the power cord from the mains wall outlet. Special antibacterial protection in top layer of inner walls prevents multiplication of bacteria and maintains the interior clean and germ free. Make sure to remove traces of any cleansing agents you had been using. • Clean the exterior of the appliance with water and liquid detergent.
Troubleshooting guide Fault: Cause/Remedy The appliance does not • Check if there is power in the socket and if the appliance is operate after connection to the switched on. mains: Cooling system operates continuously without intermittent stoppages: • Ambient temperature too high. • Frequent opening of the door, door open too long. • Door not closed properly (particle between door gasket, sagged door, check gasket sealing, etc...). • Excessive quantity of fresh food inserted at once.
Fault: Cause/Remedy Bulb replacement: • Before replacing the light bulb, disconnect the appliance form the power supply (pull the power cord from the wall socket). A – Use the screwdriver to press the locking hook (in arrow direction), and remove the cover. B – Insert the screwdriver into the cover slot, lift it and remove the cover. Replace the bulb with the equivalent new bulb (E 14, same voltage as the original one) and replace the cover back to its position.
COMBI 54 181300/en (03-09)