Troubleshooting guide

181300

Fault: Cause/Remedy

Bulb replacement:

• Before replacing the light bulb, disconnect the appliance form the

power supply (pull the power cord from the wall socket).

A – Use the screwdriver to press the locking hook (in arrow

direction), and remove the cover.

B – Insert the screwdriver into the cover slot, lift it and remove the

cover.

Replace the bulb with the equivalent new bulb (E 14, same

voltage as the original one) and replace the cover back to its

position.

• Don’t forget: the old bulb does not belong to organic waste.

• Light bulb is consumption material and is not covered by the

warranty!

Helpful hints • If none of the above proves effective and you can not remove

the fault yourself, disconnect the appliance from the mains ( see

chapter regarding the ON/OFF function), pull the power cord from

the wall socket, wait for approximately 10 minutes and reconnect

the appliance.

If the fault persists call the nearest service center and tell them

the information from the rating plate: type of appliance, model and

serial number, located inside the appliance.

The refrigerator – freezer appliances are cooled by the refrigeration system with a compressor

(assisted by fan in certain models) whose operation may produce certain noise. The level of such

noise depends upon the location, correct use and age of the appliance.

• After starting the appliance, the operation of the compressor (the refrigerant ﬂ ow) may be

somewhat louder. This does not mean that something is wrong with the appliance, neither has

it any inﬂ uence on the lifetime of the appliance. Gradually the noise is reduced and eventually

subsides.

• Sometimes the appliance produces unusual and stronger noise which is rather unusual for the

appliance. This noise is often the consequence of inadequate positioning of the appliance:

- The appliance should be placed and leveled ﬁ rmly on solid base.

- It should not touch the wall or adjacent kitchen units standing next to it.

- Check whether the accessories in the interior of the appliance are placed correctly in their

positions; also check the bottles, tins and other vessels that might touch each other and rattle.

THE MANUFACTURER RESERVES THE RIGHT TO

ALTER THE SPECIFICATIONS WITH NO IMPACT TO THE

FUNCTIONAL OPERATION OF THE APPLIANCE.

Noise level