CV102A CV102AP CV102F en it pt ar es Instruction Manual Manuale di istruzioni Manual de Utilização ﺩﻟﻴﻞ ﺍﳌﺴﺘﺨﺪﻡ Manual del usuario
Please read this user manual first! Dear Customer, We hope that your product, which has been produced in modern plants and checked under the most meticulous quality control procedures, will provide you an effective service. Therefore, read this entire user manual carefully before using the product and keep it as a reference. If you handover the product to someone else, give the user manual as well. The user manual will help you use the product in a fast and safe way.
CONTENTS 1 Your refrigerator 3 2 Safety and environment instructions 4 3 Installation 6 Maintenance and cleaning 17 7 Troubleshooting 18 7 Points to be paid attention to when the relocation of the refrigerator ...............7 Electrical connection..........................7 Disposing of the packaging ...............8 Disposing of your old refrigerator .......8 Placing and Installation ......................8 Adjusting the legs ..............................9 Reversing the doors ...................
1 Your refrigerator 23 1 4 5 6 6 7 1. 2. 3. 4. 5. 6. 7. Top trim Indicator lights Thermostat knob Ice bank Fast-freeze compartment Frozen-food compartments Adjustable front feet C Figures that take place in this instruction manual are schematic and may not correspond exactly with your product. If the subject parts are not included in the product you have purchased, then it is valid for other models.
2 Safety and environment instructions This section provides the safety instructions necessary to prevent the risk of injury and material damage. Failure to observe these instructions will invalidate all types of product warranty. 1.1. General safety This product should not be used by persons with physical, sensory and mental disabilities, without sufficient knowledge and experience or by children.
Do not use steam or steamed cleaning materials for cleaning the refrigerator and melting the ice inside. Steam may contact the electrified areas and cause short circuit or electric shock! Do not wash the product by spraying or pouring water on it! Danger of electric shock! In case of malfunction, do not use the product, as it may cause electric shock. Contact the authorised service before doing anything. Plug the product into an earthed socket. Earthing must be done by a qualified electrician.
If there is risk of water hammer effect in your installation, always use a water hammer prevention equipment in your installation. Consult Professional plumbers if you are not sure that there is no water hammer effect in your installation. Do not install on the hot water inlet. Take precautions against of the risk of freezing of the hoses. Water temperature operating interval shall be 33°F (0.6°C) minimum and 100°F (38°C) maximum. Use drinking water only. 1.2.
3 Installation B In case the information which are given in the user manual are not taken into account, manufacturer will not assume any liability for this. the fridge door is opened, fridge internal lamp will turn on. 4. When the compressor starts to operate, a sound will be heard. The Points to be paid attention to when the relocation of the refrigerator 1 2 3 3 1. Your refrigerator should be unplugged.Before transportation of your refrigerator, it should be emptied and cleaned. 2.
Disposing of your old refrigerator Electrical safety of your refrigerator shall be guaranteed only if the earth system in your house complies with standards. The voltage stated on the label located at left inner side of your product should be equal to your network voltage. Extension cables and multi plugs must not be used for connection. B A damaged power cable must be replaced by a qualified electrician.
Adjusting the legs If your refrigerator is unbalanced; You can balance your refrigerator by turning its front legs as illustrated in the figure. The corner where the leg exists is lowered when you turn in the direction of black arrow and raised when you turn in the opposite direction. Taking help from someone to slightly lift the refrigerator will facilitate this process.
Reversing the doors Proceed in numerical order 10 EN
11 EN
4 Preparation Your refrigerator should be installed at least 30 cm away from heat sources such as hobs, ovens, central heater and stoves and at least 5 cm away from electrical ovens and should not be located under direct sunlight. The ambient temperature of the room where you install your refrigerator should at least be 10°C. Operating your refrigerator under cooler conditions is not recommended with regard to its efficiency. Please make sure that the interior of your refrigerator is cleaned thoroughly.
5 Using your cooler/freezer Setting the operating temperature 2 1 3 LED indicators and control panel There are two coloured indicator lights located on the front of the appliance which shows the operating mode of the freezer. Green Indicator (1): Illuminates when the appliance is connected to the mains and will glow as long as electricity is available. The green light will not glow if the thermostat is set to ‘0’ position.
Warm Cold 1 = Lowest cooling setting (Warmest setting) 4 = Highest cooling setting (Coldest setting) (Or) Min. = Lowest cooling setting (Warmest setting) Max. = Highest cooling setting (Coldest setting) Please choose the setting according to the desired temperature. The interior temperature also depends on ambient temperature, the frequency with which the door is opened and the amount of food kept inside. Frequently opening the door causes the interior temperature to rise.
Defrosting of the appliance 1- -2 4- -3 Excessive build-up of ice will affect the freezing performance of your appliance. It is therefore recommended that you defrost your appliance at least twice a year, or whenever the ice build-up exceeds 7 mm. Defrost your appliance when there is only little or no food in it. A Attention Keep the already deep-frozen food always separated with freshly placed food. When deep-freezing hot food, the cooling compressor will work until the food is completely frozen.
Check regularly to see if the drain pipe is clogged or not and clear it with the stick in the hole when necessary.
6 Maintenance and cleaning Cleaning your fridge at regular intervals will extend the service life of the product. B WARNING: Unplug the product before cleaning it. Never use gasoline, benzene or similar substances for cleaning purposes. Never use any sharp and abrasive tools, soap, household cleaners, detergent and wax polish for cleaning. For non-No Frost products, water drops and frosting up to a fingerbreadth occur on the rear wall of the Fridge compartment.
7 Troubleshooting Check this list before contacting the service. Doing so will save you time and money. This list includes frequent complaints that are not related to faulty workmanship or materials. Certain features mentioned herein may not apply to your product. The refrigerator is not working. The power plug is not fully settled. >>> Plug it in to settle completely into the socket. The fuse connected to the socket powering the product or the main fuse is blown. >>> Check the fuses.
Large quantities of hot food may have been recently placed into the product. >>> Do not place hot food into the product. The doors were opened frequently or kept open for long periods. >>> The warm air moving inside will cause the product to run longer. Do not open the doors too frequently. The freezer or cooler door may be ajar. >>> Check that the doors are fully closed. The product may be set to temperature too low.
cause noise. >>> Remove any items placed on the product. The product is making noise of liquid flowing, spraying etc. The product’s operating principles involve liquid and gas flows. >>> This is normal and not a malfunction. There is sound of wind blowing coming from the product. The product uses a fan for the cooling process. This is normal and not a malfunction. There is condensation on the product’s internal walls. Hot or humid weather will increase icing and condensation.