User manual

USE - 11914779624/B
e
Creation of the account
1. Launch the SmegConnect App.
2. Enter the information required in order to
register.
3. A confirmation e-mail is sent to the address
that has been entered when the registration
procedure has been completed.
Product registration
The registration step is formed by alternated
operations to be made in the App and on
the control panel of the appliance . Make
sure you are close to the appliance.
Connection to the device
1. Tap Log in.
2. In the following screen (Home page), tap
Add product.
3. Select the type of product you wish to
connect (in this case "wine cellar").
4. Press any key on the device to activate the
control panel.
5. Hold down the Connection key for a
few seconds. The device enters the
SmegConnect menu; the display shows
.
6. Press and hold the light forced
key
within 30 seconds until it starts flashing.
7. Select Manual mode.
8. Go to the Wi-Fi settings on the mobile
device and select the “smegconnect”
network.
9. Enter the password “smeg0001” and wait
for the connection to be established.
10.Go back to the SmegConnect App and tap
Next.
11.Press the
Fan key on the appliance
within one minute, to confirm your presence.
The Connection key starts flashing.
12.Enter the Access Point data:
• Name of the home Wi-Fi network.
• Wi-Fi password.
13. Tap Next and wait for the confirmation
page.
14. Wait for the confirmation acoustic signal.
The product registration procedure is
completed.
The device is connected to the Internet and can
be remotely controlled.
The fields marked with an asterisk “*”
are mandatory.
If Connection Failed is
displayed during registration, it means
that some passages of the procedure
did not work properly or were
interrupted.
To remove press the
Alarm
key (wine cellars with single
compartment) or the display
for upper
compartment display
(wine
cellars with double compartment).
The procedure can be interrupted at
any time by pressing the
Connection
key.
The device supports network names
(SSID) up to 24 digits (including
spaces) and WPA2 security settings
(not WEP or WPA).
During this step, the mobile device
automatically reconnects to the initial
Wi-Fi network or data network. No user
operation is required.