User manual

ManualsBrandsSmeg ManualsMajor AppliancesWine Cooler Dolce Stil Novo

PRECAUTIONS - 9914779624/B

PRECAUTIONS 9

General safety instructions 9

Declaration of conformity 10

Declaration art. 10.10 Directive 2014/53/EU 10

This user manual 10

How to read the user manual 10

USE 10

SmegConnect 10

Connectivity requirements 10

Installation of the App 10

Creation of the account 11

Product registration 11

Connection to the device 11

Remote connection 12

Change Access Point credentials 12

Information on the connection 13

Deletion of the registration 13

Software updates 13

What to do if... 13

We advise you to read this manual carefully, which contains all the instructions for maintaining the

appliance’s aesthetic and functional qualities. For further information on the product: www.smeg.com

Apple, App Store and iOS are trademarks of Apple Inc.

Google Play Store and Android are trademarks of Google Inc.

Wi-Fi is a trademark of Wi-Fi Alliance.

PRECAUTIONS

General safety instructions

• The use of the App requires the

availability of a WLAN (Wi-Fi)

network with dedicated Internet

router, for the connection

between appliance and mobile

device.

• In case of poor signal for the

use of the appliance, envisage

to install a Wi-Fi repeater

nearby.

• Outside the coverage range of

the Wi-Fi network, the use of

the App involves the availability

of a data link for the mobile

device. CAUTION: additional

costs might arise depending on

the contract with the mobile

phone operator.

• The appliance can operate off-

line as a "non-connected"

household appliance, but it

cannot be controlled through

the App when the Wi-Fi

connection or the data link are

deactivated.

• In compliance with the

provisions regarding

electromagnetic compatibility,

the appliance belongs to group

2 and class B (EN 55011).

• This appliance complies with

the current standards and

directives regarding safety and

electromagnetic compatibility.

It is however recommended for

pacemaker wearers to

maintain a minimum distance of

20-30 cm between the

appliance when it is operating

and the pacemaker. Consult

the pacemaker manufacturer

for more information.

• In some models only, for safety

Summary of content (6 pages)

PAGE 1
PRECAUTIONS 9 General safety instructions Declaration of conformity Declaration art. 10.10 Directive 2014/53/EU This user manual How to read the user manual 9 10 10 10 10 USE 10 SmegConnect Connectivity requirements 10 10 Installation of the App Creation of the account Product registration Connection to the device Remote connection Change Access Point credentials Information on the connection Deletion of the registration Software updates What to do if...
PAGE 2
reasons and in compliance with current legislation, some functions cannot be activated remotely. Declaration of conformity The manufacturer, SMEG, declares that the types of radio equipment: CVI118RWS2 - CVI118LWS2 CVI118RWN2 - CVI118LWN2 CVI318RWX2 - CVI318LWX2 CVI618RWNR2 - CVI618LWNR2 CVI618RWNX2 - CVI618LWNX2 CVI638RWN2 - CVI638LWN2 CVI338RWX2 - CVI338LWX2 CVI138RWS2 - CVI138LWS2 CVI621LWNR3 - CVI621RWNR3 CVI621LWNX3 - CVI621RWNX3 CVI638LWN3 - CVI638RWN3 comply with the directive 2014/53/EU.
PAGE 3
Creation of the account 1. Launch the SmegConnect App. 2. Enter the information required in order to register. The fields marked with an asterisk “*” are mandatory. 3. A confirmation e-mail is sent to the address that has been entered when the registration procedure has been completed. 4. Press any key on the device to activate the control panel. 5. Hold down the Connection key for a few seconds. The device enters the SmegConnect menu; the display shows . 6.
PAGE 4
Remote connection 5. Press and hold the ON/OFF key within 30 seconds until it starts flashing. On some models only, the ON/OFF key is lit only if the product has already been registered. Once the device is registered, it can be connected or disconnected from the Internet at any time. The remote connection is only available if the device has been registered. To disconnect the device: 1. At any time, press the Connection key. key stops flashing and 2. The Connection becomes solid again.
PAGE 5
be remotely controlled. If Connection Failed is displayed during registration, it means that some passages of the procedure did not work properly or were interrupted. To remove press the Alarm key (wine cellars with single compartment) or the display for upper compartment display (wine cellars with double compartment). 3. Within 30 seconds press simultaneously the keys and for a few seconds until they start flashing. 4. Wait for the confirmation acoustic signal.
PAGE 6
shows alternating with the temperature value. If this condition continues for more than one minute, there might be problems in the remote connection: • Check if the Wi-Fi router is switched on. • Ensure that the Wi-Fi router is not too far. • Check the conditions of the Wi-Fi network (2.4 GHz band). • Check the conditions of the Internet connection. • Press the Connection key to disconnect the device and retry the connection later on.