User manual

Installation
29
EN
5 Installation
5.1 Electrical connection
General information
• Check that the characteristics of the
electricity grid comply with the
information shown on the identification
plate. The identification plate containing
technical data, the serial number, and
brand name of the appliance is visibly
located on the appliance. The
identification plate should never be
removed.
• Check that the plug and socket are of
the same type.
• Avoid the use of transformers, adapters
or shunts as these could cause
overheating or burns.
•The plug must always be accessible
when the appliance is installed.
• Before turning the appliance on for the
first time, leave it in an upright position
for at least 2 hours.
• If it is necessary to replace the power
supply cable, the operation must be
performed only by an authorized
technician of the Technical Support
Service.
5.2 Positioning
Choice of position
The appliance must be placed in a dry
place with sufficient air circulation.
Depending on the climatic class to which it
belongs (indicated on the identification
plate applied inside the compartment), the
appliance can be used in different
temperature conditions.
DANGER
• The ground connection must be
completed in the manner indicated in the
regulations on electric installations.
• Never pull the cord to unplug it.
WARNING
• Move the appliance into the desired
position with the help of a second
person.
CAUTION
• Do not use the open door as a lever to
move the appliance into place.
• Do not apply excessive pressure to the
door when it is open.
• The appliance must not be exposed to
sunlight.
• The appliance must not be placed near
heat sources. If this is not possible, a
suitable insulation panel must be used.
• Do not place the appliance outdoors.