Instruction manual

9
EN
9
Use
Modifying the time
• Make sure that the required format (12 h
or 24 h) has been set as indicated in the
previous section.
• Keep the lever (9) pressed in the central
position for 3 seconds: the display starts
to flash.
• Modify the hours and minutes as indicated
in the “Setting the clock” section.
Water hardness settings menu
The water hardness can be set by selecting
one of the 3 settings: HARD, MEDIUM and
SOFT.
• Access the settings menu by pressing and
holding buttons (18) and (19) at
the same time for 3 seconds. Select SE02
by moving the lever: the display shows
HA02 by default (medium hardness).
• Move the lever up (+) or down (-) to set
the required level: HA01 (soft), HA02
(medium) and HA03 (hard).
• Move the lever to the central position
and press (OK) to confirm the setting.
The selection flashes for 2 seconds: the
setting is saved.
Sounds settings menu
The sounds can be enabled/disabled as
follows:
• Access the settings menu by pressing and
holding buttons (18) and (19) at
the same time for 3 seconds. Select SE03
by moving the lever (9).
• Move the lever up or down until OFF
appears on the display to disable the
sounds or ON to enable them.
• Move the lever to the central position
and press (OK) to confirm the setting.
The selection flashes for 2 seconds: the
setting is saved.