User Manual

User instructions
14
H
YCLEAN OPTION
This function performs an extra antibacterial rinse at the end of the
washing cycle, assuring a further reduction in the number of bacteria
present. In order to ensure that the antibacterial rinse is effective, the
temperature must not fall while it is in progress; if this should occur (e.g.
due to a power blackout or because the door is opened), the indicator
light flashes until the dishwasher is switched off or a new program is
selected, to warn that the antibacterial rinse has not been fully effective.
Press the button to enable/disable the option; the light illuminates to
indicate that the function is active.
EXTRA OPTIONS
-
“Flexi Tabs
” BUTTON
Ideal for multi-function detergents, this option allows washing to be
optimised, with full benefits from the combined-action tablets. When this
option is activated, any salt and rinse aid in the relative containers will
not be used.
Press buttons + (HYCLEAN OPTION button + ENERSAVE
option button) simultaneously to activate the "Flexi tabs" option; the
respective light comes on to confirm the selection.
N.B.:
When the salt and rinse aid containers are empty, the relative lights will
remain on even if the “Flexi Tabs” option is selected.
IMPORTANT:
when no longer required, the option must be deactivated by pressing
the relative buttons (the light goes out).
If the water hardness has been set on a value above H3, and the “Flexi
Tbas” option is activated, the relative light flashes, warning of a setting
error. Multi-function products are not suitable for use with very "hard"
water; this does not prevent the use of the option, but the washing
results might not be of the best.