Instruction manual

Instructions
28
6 Installation
6.1 Electrical connection
Power voltage
Danger of electrocution
• The appliance must be connected to
ground in compliance with electrical
system safety standards.
• Do not pull the cable to remove the
plug.
General information
• Check the mains characteristics
against the data indicated on
the plate. The identication plate
bearing the technical data, serial
number and brand name is visibly
positioned inside the appliance.
Do not remove this plate for any
reason.
• Make sure that the plug and socket
are of the same type.
• Avoid using adapters, gang sockets
or extensions as these could cause
overheating and a risk of burns.
• The plug must always be accessible
when the appliance is installed.
• Leave the appliance standing ver-
tically for at least two hours before
turning it on for the rst time.
• If it is necessary to replace the
power cable, this must be performed
by an authorised technician from
Technical Support Service.
6.2 Positioning
Heavy appliance
Crushing hazard
• Position the appliance with the aid
of a second person.
Pressure on the open door
Risk of damages to the ap-
pliance
• Never use the open door to lever
the appliance into place when
tting.
• Avoid exerting too much pressure on
the door when open.
• The appliance must not be exposed
to direct sunlight.
• The appliance must not be placed
near sources of heat. If this is not
possible, a suitable insulation panel
must be used.
• Do not use the appliance outdoors.
Choice of location
Always install the appliance in a dry
place with satisfactory ventilation.
• The appliance must not be installed
near heat sources. If this is not possi-
ble, a suitable insulation panel must
be used.
• If installed underneath wall units, at
least 5 cm clearance must be left.
• Ensure that the appliance is located
with sufcient space for the door to
open and for the internal drawers
and shelves to be removed, if neces-
sary.
Installation