Instruction manual

48
6.3 Installation warnings
Before using your appliance for the
rst time, please pay attention to the
following points:
• The operating voltage for your ap-
pliance is 220-240 V at 50Hz.
• The plug must be accessible after
installation.
• Your appliance may have an odour
when it is operated for the rst time.
This is normal and the odour will
fade when your appliance starts to
cool.
• Before connecting your appliance,
ensure that the information on the
data plate (voltage and connected
load) matches that of the mains
electricity supply. If in doubt, consult
a qualied electrician.
• Insert the plug into a socket with an
efcient ground connection. If the
socket has no ground contact or the
plug does not match, we recom-
mend you consult a qualied electri-
cian for assistance.
• The appliance must be connected
with a properly installed fused
socket.
The power supply (AC) and voltage
at the operating point must match
with the details on the name plate
of the appliance (the name plate
is located on the inside left of the
appliance).
• We do not accept responsibility
for any damages that occur due to
ungrounded usage.
• Place your appliance where it will
not be exposed to direct sunlight.
• Your appliance must never be used
outdoors or exposed to rain.
• Your appliance must be at least 50
cm away from stoves, gas ovens
and heater cores, and at least 5 cm
away from electrical ovens.
• If your appliance is placed next to a
deep freezer, there must be at least
2 cm between them to prevent humi-
dity forming on the outer surface.
• Do not place heavy items on the
appliance.
• Clean the appliance thoroughly be-
fore use (see Cleaning and Mainte-
nance).
• Behind the appliance, in the lower
part are the spacers that determine
the minimum distance from the rear
wall.
• The distance between the appliance
and back wall must be a maximum
of 75 mm.
Installation