User manual

Contents
27
EN
8. Installation
Excessive Weight Hazard.
Use two or more people to
move and install absorption
minibar.
Failure to do so can result in
back or other injury.
8.1 Electrical connection
Power voltage
Danger of electrocution or
electrical shock
• The appliance must be connected to
ground in compliance with electrical
system safety standards.
• Do not pull the cable to remove the
plug.
General information
• Check the mains characteristics
against the data indicated on the
plate. The identication plate bearing
the technical data, serial number and
brand name is visibly positioned inside
the appliance.
Do not remove this plate for any
reason.
• Make sure that the plug and socket
are of the same type.
• Do not use adapters, gang sockets or
extension cords as these could cause
overheating and a risk of burns.
• The plug must always be accessible
when the appliance is installed.
• Leave the appliance standing vertically
for at least two hours before turning it
on for the rst time.
• If it is necessary to replace the power
cable, this must be performed by an
authorised technician from Technical
Support Service.
8.2 Positioning
Heavy appliance
Crushing hazard
• Position the appliance with the aid
of a second person.
Pressure on the open door
Risk of damage to the appliance
• Never use the open door to lever
the appliance into place when
tting.
• Avoid exerting too much pressure
on the door when open.
• The appliance must not be exposed
to direct sunlight.
• The appliance must not be placed
near sources of heat. If this is not
possible, a suitable insulation panel
must be used.
• Do not use the appliance outdoors.
Choice of location
Always install the appliance in a dry
place with satisfactory ventilation.
• The appliance must not be installed
near heat sources. If this is not possi-
ble, suitable insulation must be used.
• If installed underneath wall units, at
least 2
”
clearance must be left.
• Ensure that the appliance is located
with sufcient space for the door
to open and for the internal draw-
ers and shelves to be removed, if
necessary.
Installation