User manual

Cleaning and maintenance
45
EN
4.5 Replacing the lamp
The refrigerator lamp is next to the
refrigerator thermostat; to replace:
1. Open the bulb housing, close to the
thermostat knob, on the right of the
appliance refrigerator cell.
2. Remove the bulb to be replaced
3. Replace the bulb using the same type
of bulb.
4.6 What to do if...
The appliance does not work:
• Make sure that the appliance is plugged
in and that the main switch is turned on.
The compressor starts to function too often
or functions continuously:
• The room temperature is too high.
• The door is being opened too often or
for too long.
• The door is not closing/sealing properly.
• The freezer is loaded with too many fresh
foods.
• Check that sufficient air can circulate
around the sensor on the right-hand side
of the refrigerator compartment.
• Check that the back of the freezer is
properly ventilated and that the
condenser is not too dirty.
Power voltage
Danger of electrocution
• Turn off the appliance and unplug it from
the mains before replacing the bulb.
• The indication on the bulb holder
refers to filament bulbs. Only use
S25-E14 LED bulbs, max. 1.5
W.
• After bulb replacement, wait for
5 minutes before plugging in the
plug.