Operation Manual

6
7. TECHNICAL DATA
This appliance meets the provisions of the
following directives:
89/336/EEC (electromagnetic compatibility),
73/23/EEC (electrical equipment designed
for use within certain voltage limits) as
amended.
Household appliances sold in the EU also
meet 96/57/EEC (energy efficiency require-
ments) as amended.
The rating plate, which is placed either at the
back or inside the appliance, see fig. (7)
page 25, provides various technical informa-
tion as well as type and serial number.
8. INSTALLATION
See drawings (1) and (2) page 24.
Install the cabinet in a dry place and so that it
is not exposed to direct sunlight or any other
source of heat.
Place the cabinet in a level position. This is
easily achieved by adjusting the adjustable
feet at the front edge of the base. The
cabinet should not rest against a wall on its
hinged side. When placing the cabinet on a
carpet or on a wooden floor, the placing
should be checked after a while to see
whether the unit has „subsided“ into the soft
flooring.
The cabinets can be built in or put side by
side, see fig. (2) page 24.
KF models put side by side with other
models require a distance of 30 mm between
the appliances.
For sufficient airflow around the cabinet it is
necessary to have a 50 mm high air duct
right above the appliance, see fig. (2), an air
duct that leeds the air up over the top
cupboard.
Make sufficient space for door opening as to
draw the baskets out, see fig. (2e).
The dimensions for building in are noted on
the drawings.
It is safest to place the earthed wall socket
above the appliance and at least 2.0 m
above the floor.
Any local installation rules for appliances of
this kind must be observed.
During a storm the electricity supply might be
cut off.
You should be aware of this when installing
the appliance in weekend cottages or
elsewhere where you would not immediately
observe that the power has been cut off.
Construction and details in the accessories
are subject to alteration without previous
notice.
If the cabinet is to be adjusted:
See drawings (1) page 24.
Take hold of the front panel with both hands.
Then lift up the front panel and turn out the
bottom part.
Adjust the tilt of the unit
See drawings (1) page 24.
by turning the adjustable feet with a 13 mm
spanner.
Adjusting the door
See drawings (1) page 24.
If the door bumps against the bottom panel,
this can be remedied by adjusting the feet as
shown on the drawing.
Side by side
See drawings (2) page 24.
Concerns all fridge/freezer models:
If 2 appliances are to be placed side by side,
the minimum distance between these must be
30 mm. The distance to other sources of heat
must also be at least 30 mm.