User manual

Please Note

Electrical connection

The oven is fitted with a plug and must be only connected to a properly installed earthed

socket. In accordance with the appropriate regulations, the socket must only be installed and

the connecting cable must only be replaced by a qualified electrician.

If the plug is no longer accessible following installation and all-pole isolating switch must

be present on the installation side with a contact gap at least 3mm.

A. Built-in furniture

The built-in cabinet shall not have a rear wall behind the appliance.

Minimum installation height is 85cm.

Do not cover ventilation slots and air intake points.

380+2

PAGE 1
EN Please Note Electrical connection The oven is fitted with a plug and must be only connected to a properly installed earthed socket. In accordance with the appropriate regulations, the socket must only be installed and the connecting cable must only be replaced by a qualified electrician. If the plug is no longer accessible following installation and all-pole isolating switch must be present on the installation side with a contact gap at least 3mm. A.
PAGE 2
EN Screw Bracket Trim-kit plastic cover B. Prepare the Cabinet. 1 297 36 357 420 10 3 FRONT BOTTON CABINET TEMPLATE 1. Put the BOTTOM CABINET TEMPLATE on the bottom plane of cabinet. And make the center line of the template coincides with the bottom of cabinet.
PAGE 3
EN 2 2*Screw Bottom Bracket 2. Fix the BOTTOM BRACKET with two SCREW . And remove the BOTTOM CABINET TEMPLATE . C.. Install the oven. 3 3. Install the oven into the cabinet. z Do not trap or kink the power cord.
PAGE 4
EN 4 bracket 4. Bottom Bracket is just installed against the back shell of the oven. 5 Screw Installation Hole 5. Open the door; fix the oven to the cabinet with SCREW at the INSTALLATION HOLE of TRIM KIT. Then fix the TRIM-KIT PLASTIC COVER to the INSTALLATION HOLE.