FAQ

Description Installation

1 Description

1 Grid

2 Burner cap

2 Installation

Proceed as follows to replace the grids and

burner caps:

1. Pull one of the two horizontal spokes of

the grids upwards to remove them.

2. Remove the burner caps.

3. Fit the EVERSHINE treated burner caps

to the corresponding burners.

4. Position the EVERSHINE treated grids,

taking care that the pins A line up with

their seats on the hob, then press down

with your palm until they click into place.

The special EVERSHINE treatment

makes the stainless-steel burner

caps and grids highly heat resistant,

preventing yellowing due to high

temperatures.

PAGE 1
Description Installation EN 1 Description 1 Grid 2 Burner cap The special EVERSHINE treatment makes the stainless-steel burner caps and grids highly heat resistant, preventing yellowing due to high temperatures. 2 Installation Proceed as follows to replace the grids and burner caps: 1. Pull one of the two horizontal spokes of the grids upwards to remove them. 2. Remove the burner caps. 3. Fit the EVERSHINE treated burner caps to the corresponding burners. 4.
PAGE 2
Cleaning and maintenance 3 Cleaning Improper use Risk of damage to surfaces • Do not use steam jets for cleaning the components. • Use hot or warm water to clean. • For stubborn dirt, use neutral, nonabrasive detergents. • Do not use cleaning products containing chlorine, ammonia or bleach. • Use soft materials (cloths, sponges, chamois) for cleaning and drying. • Do not use rough or abrasive materials.