Operation Manual

Instructions for the user
39
7 USING THE HOB
Before turning on the burners, make sure that the burner rings, caps
and grids have been fitted correctly.
In the ultrarapid burner, notch A must be aligned with pin B.
Grid C provided is intended for use with woks (Chinese pans).
Adapter D comes only with open grids models and is intended for use
with small sized vessels.
7.1 Ignition of the burners
d to the ignition symbol before it is pressed, and after
g the knob pressed for more than 2
econds.
The device is fit with electronic ignition. Simply press and
simultaneously turn the knob counter-clockwise on the low point flame
symbol, until the burner is ignited. In models with safety valve, the knob
as to be turneh
ignition the knob has to be kept pressed for about 2 seconds to keep
the flame lit and to activate the safety device.
The burner might go off when the knob is released. In this case repeat
the aforesaid operation keepin
s
Should the burners go off accidentally in the models with valves, a
safety device will trip after approximately 20 seconds to block the gas
outlet even if the cock is open.
.2 Practical advice for using the burners
o avoid overcooking or damage to the surface top
7
For better burner performance and minimum gas
consumption, flat bottomed, even pans must be used,
with covers and proportional in size to the burners (see
aragraph “7.3 Diameter of the pans”). p
T