User Manual

Use
14
10. Pick up the kettle by the handle and
pour the hot water into the desired
recipient (cups, teapot etc.).
11. If no command is given within 60
seconds, the kettle will enter Stand-by
mode (all LEDs off). Pressing any key will
reactivate the kettle, placing it in
Temperature SELECTION mode starting
from the last temperature set. Now
follow the operations from point 7
onwards in section ”3 Use”.
3.3 Keep Warm function
This function allows you to keep the water in
the kettle at the selected temperature for a
maximum of 20 minutes.
This function can be activated at any
moment during the heating cycle by
pressing the Keep Warm key (the
corresponding LED turns on to confirm the
selection). Pressing the key again exits then
Keep Warm function and the LED will turn
off. After 20 minutes have passed, the kettle
enters Stand-by mode.
3.4 Mute function
This function allows you to deactivate the
kettle ON/OFF, START/STOP, and end of
cycle sounds.
The function can be activated by pressing
the Keep Warm key for 5 seconds (the
corresponding LED lights up and flashes
while the operation is stored).
Pressing the Keep Warm key again for 5
seconds (the corresponding LED will light
up and flash) exits the Mute function,
reactivating the sounds.
Danger of burns
• Wait a few seconds from when the
kettle boils, then pour the water out
slowly to prevent it spraying or coming
out too fast.
• Do not fill the kettle beyond the
maximum level (1.7 litres) – risk of burns
when pouring.
• Do not tilt the hot kettle excessively – the
boiling water could spray out, with a risk
of burns.
• Keep your face at a safe distance from
the lid to avoid the risk of burns from
escaping steam.