Instruction Manual

METAL FILTERS CLEANING:

CARBON FILTERS REPLACEMENT: (For recirculated version only)

Special attention should be reserved to the metal

grease filters. An excess of grease in the filter, as well

as affecting the performance of the hood, can also be

a fire risk. To avert fires, the filters must be cleaned

regularly at least once a month or more frequently, in

the case of a heavy use of the appliance.

According to your hood’s model, remove one filter at a

time as shown in these pictures. Wash the filters

thoroughly with a non-bleach detergent, either by hand

or machine. Re-assemble the filters, making sure that

the handle faces the outside of the hood.

The carbon filters can only retain odours for a limited

period of time. They cannot be washed, therefore, it is

recommended they are replaced at least once every

six months or more frequently in the case of a heavy

use of the appliance.

Before starting, make sure the hood is disconnected

from the mains supply.

To reach the active carbon filters, it is necessary to

remove the metal filters as shown above. Use the

pictures to find the carbon filter kit of your hood.

Round filter: simply rotate the filters 90 degrees as

shown in fig. A and then remove them from their

seats.

Spring-held cartridge filter (fig. B): press enough to

overcome the spring’s resistance and remove the

filter.

Cartridge filter with bracket and threaded knob (fig.

C): unscrew the knob, remove the blocking racket and

then remove the active carbon filter.

Re-assemble the carbon and metal filters performing

the above mentioned operations backwards.

Note: only for the electronic controlled hood, reset the

filters cleaning warning by pressing the Filter reset

button.