Dishwasher Instruction Manual

User instructions
FAULT DESCRIPTION
E5
The dishwasher fails to draw water.
Check that:
• the water supply tap is open;
• the filter in the water intake hose is not clogged;
• the water intake hose is not kinked or bent;
Turn the dishwasher off and then on again, then press the
START/PAUSE button (3) again. If the problem is resolved the
washing program will resume from where it was halted.
If the fault persists, call the authorised technical service centre.
E6
The dishwasher fails to drain.
Check that:
• the flexible drain hose is not kinked or obstructed;
• the water drain pipe is not obstructed;
• the dishwasher filter is not clogged;
Turn the dishwasher off and then on again, and then press the
START/PAUSE button (3) again. If the problem is resolved, the
washing program will resume from where it was halted.
Otherwise, if the fault persists, call the authorised technical service
centre.
In the event of error codes not included in this table, call the Technical
Service Centre.
TECHNICAL DATA
Width
597 ÷ 599 mm
Depth measured flush with the
outer edge of the control panel
Free standing: 600 mm
Semi-integrated: 570 mm
Height (depending on models)
Free standing: from 850 mm to 870 mm
from 890 mm to 910 mm
Semi-integrated: from 820 mm to 870 mm
from 860 mm to 910 mm
Capacity
14 Standard place settings
Water supply pressure
min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar)
Electrical characteristics
See rating plate
36