Instruction manual

Installation

2.2 General information

 Remove the polystyrene basket retainers.

 Position the appliance in the desired place of installation.

 This appliance may be placed up against walls or other furniture units.

 If the appliance is installed near a heat source, fit a special insulating panel to

prevent overheating and malfunction of the appliance.

 To ensure stability, install integrated or built-under dishwashers only under

continuous worktops, and screw them to the adjacent units.

 To facilitate the installation procedure, the intake and drain hoses can be

positioned in any direction; make sure that the hoses are not kinked, crushed or

pulled too tightly.

 Make sure to tighten the locking ring nut once the hoses have been placed in the

direction required.

 A hole at least 8 cm in diameter is required to allow the power supply cable and

hoses to pass.

 At the end of the installation, perform a short test of the appliance: open the water

tap and check that there are no leaks.

 To install the dishwasher against the back wall, the hoses should be passed

through the lower area where there is a dedicated space for them.

 The following spare parts will be available for 7 years after the model is no

longer produced: wash pump, drain pump, heating elements; pipes and hoses,

valves, filters and acquastop devices; structural and internal parts of the door

(separately or as an assembly); electronic boards and printed circuits; electronic

displays; pressure switches; thermostats and sensors, software and firmware,

including reset software.

 The following spare parts will be available for 10 years after the model is no

longer produced: door hinge and seal; other seals; spray arms; filter unit,

baskets, runners and accessories.

 Some spare parts are only available to authorised repairers.

 Not all spare parts apply to all models.

 The EU EPREL database provides information regarding dishwasher

performance. The database can be consulted directly using the QR code on the

dishwasher's energy label or via the following link. In this case, you have to

enter the name of the model indicated on the data plate on the side of the door.

For detailed information on the energy label: www.theenergylabel.eu.

Level the appliance on the floor using the appropriate Allen key to regulate

the adjustable feet. This operation is essential for ensuring correct

operation of the dishwasher.