User manual

User instructions
29
AUTOMATIC DOOR OPENING
DRY ASSIST
(always included in the ECO program)
(it may be included in other programs, please refer to the manual
supplied with the product).
The program ends with a drying cycle that consists of a time during which
the door is closed, and a time during which the door is slightly open (just
waiting, to assist drying). The duration depends on the program and
model.
Any intervention (opening / closing the door, switching off etc.) during this
stage will end the program early.
The program can be interrupted during the drying cycle and the
dishwasher can unloaded before the cycle has completely ended, which
is indicated by a visual and/or audible alarm (depending on the model),
but best drying results may not be obtained.
The complete program ends only when indicated by a visual and/or
audible signal (depending on the model).
There must be sufficient space available for the door to open. The
door must not be forced open and closed before the wash cycle has
ended completely.
Note:
some models are equipped with the dry assist function by default
on one or more cycles (check the manual supplied with the product).
These models are not fitted with a button to control this function. The door
opens automatically at the end of the wash cycle(s).
DELAY
(if present)
Press the DELAY button to set the dishwasher cycle to start during the
required time period (e.g. night). According to the model, this may be
indicated on the display or by specific lights. The option cannot be
selected once the cycle is running. To cancel the setting, press the
button several times until the lights switch off or until the number on the
display is reset. After the door has been closed, the dishwasher will carry
out a pre-wash cycle, after which the set cycle delay option will be
activated.
SELF CLEAN
(if present)
Dishwasher cleaning cycle. The cycle should be started with the machine
empty, without dishes. It is recommended to run the program every 2-3
months, using special dishwasher detergents. The light flashes during
operation. At the end of the cycle it remains on and cycle lights 4 and 5
flash.
The display (if available) shows “End”.