Operation Manual

Instructions for the User
15
EN
If you wish, at this time you can:
 Turn or stir the food to ensure it will be evenly cooked.
 Modify the process parameters.
 Cancel the process by pressing PT2 for 3 seconds.
To restart the process, close the door and press PT2.
7.6.2 Modifying parameters
The operating parameters (time, weight, power, etc.) can only be modified
when the cooking process has been interrupted. Proceed as follows:
 Press PT1 approximately 5-6 seconds to activate the parameter
modification mode. The symbol starts to blink. Turn PT1 to
the right or left to change the remaining cooking duration.
 Press PT1 for 3 seconds to validate and the next parameter
light starts to blink. Proceed as described in the active function
chapter to modify the remaining parameters.
 Press PT2 to continue the cooking process.
7.6.3 Cancelling a cooking cycle
If you wish to cancel the cooking process, press PT2 for 3 seconds.
You will then hear a beep and the oven returns to the OFF setting.
7.6.4 End of a cooking cycle
At the end of the process you will hear three beeps and the display will
show the word “End”.
The beeps are repeated every 30 seconds until the door is opened or PT2
is pressed. The oven returns to the OFF setting.
7.7 Secondary menu
This appliance also has a concealed "secondary menu" allowing the user
to:
1. Activate or deactivate the Show Room function (which disables all the
heating elements so that only the control panel works);
2. Activate or deactivate the function which limits the maximum power
absorption to 2000 W;
3. Activate or deactivate the child safety device ( );
7.7.1 Show Room Function
With the oven in OFF status (see point “7.2 Operating settings”) keep PT1
pressed between 5-6 seconds, until the message OFF SHO appears on
DSP1. This means that the SHOW ROOM function (which disables all the
heating elements so that only the control panel works) is not active.
Turn PT1 to the right or left to activate (ON SHO) or deactivate (OFF SHO)
this function. To use the oven normally, set OFF SHO.
After setting the parameter required, press PT2 to return the oven to the
initial standby status.
7.7.2 Child safety lock-out function
With the oven in OFF status (see point “7.2 Operating settings”) keep PT1
pressed until the message OFF SHO appears on DSP1. Now press PT1
until the message “OFF BLOC” appears on DPS1.