Instruction manual

Use
42
Correct positioning of the flame-
spreader crowns and burner caps
Before lighting the hob burners, make sure
that the flame-spreader crowns are
correctly positioned in their housings with
their respective burner caps. Make sure that
the holes in the burner are aligned with the
thermocouples (A) and the igniters (B).
Also make sure that the pins (C) of the
flame-spreader crowns are inserted into
their seats (D) in the burner rings.
Limitations on griddle use
A few precautions are necessary if you wish
to use a griddle:
• Griddles must never protrude beyond
the edge of the hob.
• Teflon-coated aluminium griddles should
be pre-heated empty for a maximum of 5
minutes in order to avoid damaging the
appliance and the Teflon coating. After
pre-heating, place the foodstuffs on the
griddle to cook them; do not exceed 40
minutes of total use for the griddle.
• Do not use griddles or plates to cook or
heat food on the ultra-rapid burner (UR).
• If one of the burners close to the wooden
rear wall is an ultra-rapid burner (UR),
leave a gap of at least 160 mm between
this wall and the edge of the griddle.
• Make sure that the burner flame does
not extend beyond the edge of the
griddle.
• Leave a gap of at least 160 mm
between the edge of the griddle and the
side wall.
• Do not place the griddle over more than
one burner at the same time.
• Never use the griddle for more than 40
minutes.