Instruction manual

Installation
54
6. Remove the hob.
7. Remove the hob support plate.
Replacing nozzles
1. Unscrew screw A and push air
regulator B as far as it will go.
2. Remove the nozzles C using a 7 mm
spanner and install the ones suitable for
the new type of gas, following the
indications given in the relevant tables
(see “Gas types and Countries”).
3. Adjust the air flow by moving the air
regulator B to obtain the distance D
given in the corresponding table (see
“Gas types and Countries”).
4. After having adjusted each burner,
reassemble the appliance following the
disassembly instructions in reverse (see:
“5.5 Adaptation to different types of gas
- Removing the hob”).
The support plate must be
reinstalled with the front support
lugs (A) facing towards the gas
valves, taking care to put it back in
the same position as it was before
it was removed.
The nozzle tightening torque must
be no more than 3 Nm.