Instruction manual

21
INSTALLATION
4) FIXING
A special sealing strip underneath the hob for
damage. Make sure it is correctly positioned with no
gaps; it avoids any water infiltration. To fix in the right
way the strip, please, respect the following
instructions:
- fix the hooks in the relative accomodations of the
body (see fig. 8).
- Overturn the hob, take the seal strips off from their
support, having care that the transparent protection
remains attached to the seal. Correctly place the
seal "E" (fig. 8) under the hob edge, so that the
external side of the seal fits together with the
external perimentrical edge of the hob. The ends of
the strip must fit together without overlapping.
- Stick the seal to the hotplate uniformly, pressing it
with fingers.
- Take the protective paper strip of the seal off, place
the hotplate in the opening made in the table top,
and lock it with the special screws "F" (fig. 9).
- Since the casing of the hob may overheat due to a
prolonged use, it is necessary to insert a
separation plane wood, blocked by screws, which
must be installed under the cooktop at a minimum
distance of 70 mm from the top, as shown in fig.6.
WARNINGS:
be aware that the glue that join the laminated
plastic to the furniture, has to resist to
temperature not below 150 °C, to avoid the
unstuck of the panelling.
The rear wall, adjacent and surrounding surfaces
must therefore be able to withstand an
temperature of 90 °C.
FIG. 8 FIG. 9