User manual

Problem Possible cause Solution
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor-
ing.
The water drainage plug is
not correctly positioned.
Position the water drainage
plug in the correct way.
Food products are not
wrapped properly.
Wrap the food products better.
Temperature is set incor-
rectly.
Refer to "Operation" chapter.
Water flows inside the refrig-
erator.
The water outlet is clog-
ged.
Clean the water outlet.
Food products prevent that
water flows into the water
collector.
Make sure that food products
do not touch the rear plate.
Water flows on the floor. The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
Attach the melting water outlet
to the evaporative tray.
The temperature in the appli-
ance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower temperature.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' tem-
perature is too high.
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Many food products are
stored at the same time.
Store less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened
often.
Open the door only if necessa-
ry.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Replacing the lamp
1. Disconnect the plug from the mains
socket
2. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction of
the arrows.
43