Table of Contents 1.1 1.2 1.3 1.4 1.5 10 General Description Cooktop Control panel Other parts Available accessories 2 Use 2.1 2.2 2.3 2.4 2.5 2.6 2.7 10 10 11 11 12 13 Instructions First use Using the accessories Using the cooktop Using the main oven Cooking advice Programming clock 3 Cleaning and maintenance 3.1 3.2 3.3 3.4 3.
Important Safety Instructions TIP OVER HAZARD WARNING • A child or adult can tip the range and be killed. • Make sure that the anti-tip device has been properly installed and attached. The wall-mounted brackets should anchor the sides of the range (primary system) or, in case of floormounted brackets, they should anchor the rear of the range to the ground. • Make sure that the anti-tip device is re-attached when the range is moved.
Important Safety Instructions WARNING EN • This appliance is intended for use in the home only. • Use this appliance only for its intended purpose. The manufacturer cannot be held liable for damage caused by improper use of this range. • This appliance complies with current safety regulations. Improper use of this range can result in personal injury and material damage. • Read all the instructions before installing or using the range for the first time.
Important Safety Instructions WARNING PRIMARY FASTENING SYSTEM: Visually check that the wall-mounted brackets are inserted into the appropriate lateral hooks (on both sides). SECONDARY FASTENING SYSTEM: Visually check from the inside of the drawer that the floor-mounted bracket is inserted into the appropriate lateral hooks (left or right). • Proper installation is your responsibility. Make sure your appliance is properly installed and grounded by a qualified installer.
• DO NOT TOUCH SURFACE BURNERS OR THE INSIDE OF THE APPLIANCE: Heating elements may be hot even though they are dark in color. The oven cavity can be hot enough to cause burns. During and after use, do not touch areas near burners or the inside of the oven until they have had sufficient time to cool. Do not allow garments or any flammable material to come into contact with hot surfaces. If personal clothing or hair catches on fire, drop and roll immediately to extinguish the flames.
Important Safety Instructions • DO NOT USE ALUMINUM FOIL TO LINE ANY PART OF THE OVEN OR RANGETOP. Use of a foil liner can result in an electrical shock or fire hazard or obstruct the flow of heat and air. Foil is an excellent heat insulator, allowing heat to be trapped under it. This can interfere with cooking and can damage the enamel of the oven. • Prevent aluminum foil from contacting the heating elements. • Never leave the range unattended when using high heat settings.
• Make sure that your range is properly secured and the anti-tip device is correctly installed. Refer to the instructions inside the installation manual. • Do not stand or sit on the oven door or drawer. • Remove all packing materials and temporary labels from the oven and rangetop. • Record the Model and Serial number on Page 2 of this booklet. The Model and Serial numbers are on the Range ID plate. The ID Plates are visibly located on the back of the appliance and on the oven door frame.
Description 1 Description 1.1 General Description 1 Upstand 1 Cooktop 2 Control panel 3 Seal 4 Door 5 Fan 6 Oven light Rack/tray support frame shelf 1.
Description EN 1.3 Control panel 1 Temperature knob 5 Hob burner knobs This knob allows you to select the cooking temperature. Turn the knob clockwise to the required value, between the minimum and maximum settings. Useful for lighting and adjust the hob burners. Press and turn the knobs anti- 2 Indicator light The indicator light comes on to indicate that the oven is heating up. It turns off as soon as it reaches the set temperature.
Description Cooling fan Rack The fan cools the oven and comes into operation during cooking. The fan causes a steady outflow of air that exits from the rear of the appliance and which may continue for a brief period of time even after the appliance has been turned off. Useful for supporting containers with food during cooking. Ring reducers Do not obstruct ventilation openings and heat dispersal slots. Useful when using small cookware. Handrail 1.
Use 2.1 Instructions High temperature inside the oven during use Danger of burns • Keep the oven door closed during cooking. • Protect your hands wearing heat resistant gloves when moving food inside the oven. • Do not touch the heating elements inside the oven. • Do not pour water directly onto very hot trays. • Do not allow children younger than 8 years old to come near the appliance when in operation.
Use High temperature inside the oven during use Danger of fire or explosion • Do not spray any spray products near the oven. • Do not use or leave flammable materials near the oven or the storage compartment. • Do not use plastic kitchenware or containers when cooking food. • Do not put sealed cans or containers in the oven. • Do not leave the oven unattended during cooking operations where fats or oils could be released. • Remove all trays and racks which are not required during cooking.
2.3 Using the accessories Reduction pan stands Racks and trays The reduction pan stands have to be placed on the hob grids. Make sure they are properly placed. Racks and trays have to be inserted into the side guides until they come to a complete stop. • The mechanical safety locks that prevent the rack from being taken out accidentally have to face downwards and towards the oven back. EN Use 2.
Use After lighting, keep the knob pressed in for a few seconds to allow the thermocouple to heat up. The burner may go out when the knob is released: in this case, the thermocouple has not heated up sufficiently. Wait a few moments and repeat the operation. Keep the knob pressed in longer. In case of an accidental turning off, a safety device will be tripped, cutting off the gas supply, even if the gas tap is open. Return the knob to and wait at least 5 minutes before lighting it again.
Use 2.5 Using the main oven EN Refer to the following chart as a guide to the physical properties of cookware. Aluminum • Heats quickly and evenly. • Suitable for all types of cooking. • Medium or heavy thickness is best for most cooking tasks. Cast iron • Heats slowly and evenly. • Good for browning and frying. • Maintains heat for slow cooking. Ceramic or glass-ceramic • Follow the manufacturer’s instructions. • Heats slowly but unevenly. • Best results with low to medium heat settings.
Use Small grill Using only the heat released from the central element, this function enables small portions of meat and fish to be grilled for making kebabs, toasted sandwiches and all types of grilled vegetable side dishes. Grill The heat coming from the grill element gives perfect grilling results above all for thin and medium thickness meat and, in combination with the rotisserie (where fitted), gives the food an even browning at the end of cooking. Perfect for sausages, spare ribs and bacon.
2.6 Cooking advice General advice • Use a fan-assisted function to achieve uniform cooking at several levels. • It is not possible to shorten cooking times by increasing the temperature (the food could be overcooked on the outside and undercooked on the inside). • Using more ovens at the same time might affect the final cooking results. Advice for cooking meat • Cooking times vary according to the thickness and quality of the food and to consumer taste.
Use Advice for defrosting and proving • Place frozen foods without their packaging in a lidless container on the first shelf of the oven. • Avoid overlapping the food. • To defrost meat, use the rack placed on the second level and a tray on the first level. In this way, the liquid from the defrosting food drains away from the food. • The most delicate parts can be covered with aluminium foil. • For successful proving, a container of water should be placed in the bottom of the oven.
Minute minder timer Setting the time If the time is not set, the oven will not switch on. On the first use, or after a power failure, the digits will be flashing on the appliance’s display. 1. Keep the clock key for two seconds. The dot between the hours and the minutes flashes. 2. The time can be set via the value increase key and value decrease key . Keep the key pressed in to increase or decrease rapidly. 3. Wait 7 seconds. The dot between the hours and the minutes stops flashing.
Use Timed cooking Timed cooking is the function which allows a cooking operation to be started and then ended after a specific length of time set by the user. 1. Keep the clock key pressed for a few seconds. The display shows the figures and the symbol flashing between the hours and minutes. 2. Press the clock key again. On the display the digit appear alternating with the digit and the symbol flashing under the minutes. 3.
Programmed cooking Programmed cooking is the function which allows a cooking operation to be started at a set time and then ended after a specific length of time set by the user. 1. Set the cooking time as described in the previous point “Timed cooking”. 2. Press the clock key again. On the At the end of cooking the heating elements will be deactivated. On the display, the symbol turns off, the symbol flashes and the buzzer sounds. 6. To turn the buzzer off, simply press one of the programmer clock keys.
Use Cooking information table Weight (Kg) Function Shelf Temperature (°C) Time (minutes) Lasagne Pasta bake 3-4 3-4 Convection Convection 1 1 220 - 230 220 - 230 45 - 50 45 - 50 Roast veal Pork Sausages Roast beef Roast rabbit Turkey breast Roast pork neck Roast chicken 2 2 1.5 1 1.5 3 2-3 1.
3 Cleaning and maintenance 3.2 Cleaning the appliance 3.1 Instructions To keep the surfaces in good condition, they should be cleaned regularly after use. Let them cool first. WARNING ELECTRICAL SHOCK HAZARD • Before servicing, disconnect the appliance from the power supply. Improper use Risk of damage to surfaces • Do not use steam jets to clean the appliance. • Do not use cleaning products containing chlorine, ammonia or bleach on steel parts or parts with metallic finishes on the surface (e.g.
Cleaning and Maintenance Flame spreaders and burner caps Cleaning the oven cavity For easier cleaning, the flame spreaders and the burner caps can be removed. Wash them in hot water and non-abrasive detergent. Carefully remove any encrustation, then wait until they are perfectly dry. Refit the flame spreaders making sure that they are correctly positioned in their housings with their respective burner caps. Visually checking pilot(s) and burner flames.
2. Grasp the door on both sides with both hands, lift it forming an angle of around 30° and remove it. 3. To reassemble the door, put the hinges in the relevant slots in the oven, making sure that grooved sections A are resting completely in the slots. Lower the door and once it is in place remove the pins from the holes in the hinges. Removing the internal glass panes For easier cleaning the internal glass panes of the door can be removed. 1.
Cleaning and Maintenance 3. Remove the intermediate glass pane by lifting it upwards. Removing racks/trays support frames Removing the rack/tray support frames enables the sides to be cleaned more easily. To remove the rack/tray support frames: • Pull the frame towards the inside of the oven to unhook it from its groove A, then slide it out of the seats B at the back. 4. Clean the external glass pane and the panes removed previously. Use absorbent kitchen roll.
Cleaning and Maintenance 4. Slide out and remove the light bulb. EN 3.5 Extraordinary maintenance Replacing the internal light bulb Live parts Danger of electrocution • Unplug the appliance. The oven is fitted with a 40W light bulb. 1. Completely remove all accessories from inside the oven. 2. Remove the rack/tray support frames. 3. Remove the bulb cover using a tool (e.g. a screwdriver). Do not touch the halogen light bulb directly with your fingers, but wrap it in insulating material. 5.
Cleaning and Maintenance Removing and installing the door seal Minimum adjustment To remove the seal: • Unhook the clips located in the 4 corners and in the centre, then pull the seal outwards. For natural Gas: Light the burner and turn the knob to the minimum position . Remove the gas tap knob and turn the adjustment screw at the side of the tap rod until the desired minimum flame is achieved.
