SAHP86 Dryer User Manual SMEG_SAHP86_A+++/110515.
Please read this user manual first! Dear Customer, Thank you for prefering a Smeg product. We hope that your product which has been manufactured with high quality and technology will give you the best results. We advise you to read through this manual and the other accompanying documentation carefully before using your product and keep it for future reference. If you transfer the product to someone else, give its manual as well.
1 Important safety and environmental instructions This section contains safety instructions that will help protect from risk of personal injury or property damage. Failure to follow these instructions shall void any warranty. 1.
Important instructions for safety and environment 1.1.1 Electrical safety Electrical safety instructions should be followed while electrical connection is made during the installation. A • Connect the dryer to a grounded outlet protected by a fuse at the value specified on the type label. (See Overview) Have the grounding installation performed by a qualified electrician.
Important instructions for safety and environment 1.1.2 Product safety Points to be taken into consideration for fire hazard: Below specified laundry or items must not be dried in the dryer considering fire hazard. • Unwashed laundry items • Items soiled with oil, acetone, alcohol, fuel oil, kerosene, stain removers, turpentine, paraffin or paraffin removers must be washed in hot water with plenty of detergent before being dried in the dryer.
Important instructions for safety and environment Oil-affected items can ignite spontaneously, especially when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. Oxidation creates heat. If the heat cannot escape, the items can become hot enough to catch fire. Piling, stacking or storing oil-affected items can prevent heat from escaping and so create a fire hazard.
Important instructions for safety and environment • There must not be a lockable, sliding or hinged door that may block the opening of the loading door in the place where your dryer is to be installed. • Install your dryer at places suitable for home use. (Bathroom, closed balcony, garage etc.) • Make sure that pets do not enter the dryer. Check the inside of the dryer before operating it. • Do not lean on the loading door of your dryer when it is open, otherwise it may fall over.
Important instructions for safety and environment Installation Table for Washing Machine and Dryer Dryer Depth 54 cm 60 cm Washing Machine Depth 62cm 60 cm 54 cm 50 cm 49 cm 45 cm 40 cm Can be Can be Can be Can be Can be Can be Cannot be installed installed installed installed installed installed installed Can be Can be Can be Can be Can be Cannot Cannot be be installed installed installed installed installed installed installed 1.3 Intended use • Dryer has been designed for domestic use.
Important instructions for safety and environment 1.4 Children's safety • Packaging materials are dangerous to children. Keep packaging materials away from children. • Electrical products are dangerous for the children. Keep children away from the product when it is operating. Do not let them tamper with the dryer. Use the child-proof lock in order to prevent the children to tamper with the dryer. C Child-proof lock is on the control panel. (See 5.
Important instructions for safety and environment 1.7 Technical Specifications EN Height (min. / max.) Width Depth Capacity (max.) Net weight (plastic front door usage) Net weight (glass front door usage) Voltage Rated power input Model code 2 84,6 cm / 86,6 cm* 59,5 cm 60,9 cm 8 kg** 50,5 kg 52,5 kg See type label*** * Min. height: Height with adjustable feet are closed. Max. height: Height with adjustable feet are opened maximum. ** Dry laundry weight before washing.
2 Your Dryer 2.1 Package Contents 1 2 3 4 5 1. Water drain hose * 2. Filter drawer spare sponge* 3. User Manual 4. Drying basket* 5. Drying basket user manual* *It can be supplied with your machine depending on its model.
3 Installation Before the calling the nearest Authorized Service for the installation of the dryer, ensure that electrical installation and water drain is appropriate referring to the user's manual.(See 3.3 Connecting to the drain and 3.5 Electrical connection) If they are not suitable, contact a qualified electrician and technician to make necessary arrangements. C A A Preparation of the dryer's location as well as the electrical and waste water installations is under customer's responsibility.
Installation 1 2 3 4 A C C • C It is normal to hear a metallic noise from the compressor sometimes during operation. C Water collected during operation is pumped to water tank. It is normal to hear pumping noise during this process. Water drain hose should be attached to a height of maximum 80 cm. Make sure that the water drain hose is not stepped on and it is not folded between the drain and the machine.
4 Preparation 4.1 Laundry suitable for drying in the dryer Always obey the instructions given on the garment tags. Dry only the laundry having a label stating that they are suitable for drying in a dryer and make sure that you select the appropriate programme.
Preparation • • Clean the filter drawer regularly either when the Filter Drawer Cleaning warning symbol appears or after every 3 drying cycles. (See 6 Maintenance and cleaning) Ventilate the room, where the dryer is located, well during drying. 4.5 Correct load capacity Follow the instructions in the “Programme selection and consumption table”. Do not load more than the capacity values stated in the table.
5 Operating the product 5.1 Control panel 1 2 3 4 10 9 8 5 6 7 1. Programme Selection knob 2. Dryness Level Adjustment button 3. Audio Warning Level button 4. Display 5. On /Off/Cancel button 6. Start/Pause button 7. End Time button 8. Favourite button 9. Timer Programmes Selection button 10. Anti-creasing button 5.
Operating the product Cottons Synthetics Xpress Timer Freshen Up Anti program Creasing mes Filter cleaning Buzzer/ cancel Jeans BabyProtect Sport Shirts Spin Mix 4. Tank full Timer Delay Wool Refresh Drying Rack Pressing the On/Off/Cancel button does not mean that the programme has started. Press Start / Pause button to start the program. 5.4 Programme selection 1. 2. Decide the appropriate programme from the table below which includes drying levels.
Operating the product • Mix • WoolProtect Use this programme to dry non-pigmenting synthetic and cotton laundry items together. Use this programme to dry woolen garments such as jumpers that are washed according to the instructions. It is recomended that garments would be removed at the end of the programme.
Operating the product 5.7 Programme selection and consumption table EN 2 Programs Capacity (kg) Spin speed in washing Approximate amount Drying time (minutes) machine (rpm) of remaining humidity Cottons / Coloreds A Extra dry 8 1000 % 60 184 A Cupboard dry 8 1000 % 60 174 A Iron dry 8 1000 % 60 139 8 1000 % 60 240 Night Baby 3 1000 % 60 95 0.
Operating the product 5.8 Auxiliary functions Audio Warning The machine will give an audio warning when the programme comes to an end. Use the Audio Warning Level button to adjust the sound level. C You can change the sound level either before the programme starts or while the programme is in progress. Dryness level adjustment selection Dryness level adjustment button is used to adjust the required dryness level. Programme duration can change depending on the selection.
Operating the product Anti-creasing Anti-creasing programme duration may be changed with the Anti-creasing selection button. You can use Anti-creasing function to prevent laundry from creasing if you will not take the laundry out after the program has come to an end. This programme rotates the laundry in every 240 second for selected time to prevent creasing.Following images identify the level changes.
Operating the product C If loading door is opened and closed during the End Time duration, the programme will switch to pause mode. End Time function should be resumed with pressing Start/Pause button. Draining the water tank When the programme is completed, a warning symbol will appear continously to remind that the water tank needs to be drained. C For detailed information, see 6 Maintenance and cleaning.
Operating the product 5.10 Starting the programme To deactivate the childproof lock: 5.11.Progress of programme 5.13 Changing the programme after it has started Press the Start/Pause button to start the program. Start symbol will light up to indicate that the programme has started and “:” symbol in the middle of the remaining time will keep flashing. Drying and programme progress bar will be displayed alternately. • • • • • • 5.
Operating the product C If you select a new programme by turning the Programme Selection knob while your drier is in Pause mode, then the current program is aborted and new programme information is displayed. Do not touch the inner surface of the drum when adding or taking out laundry while a programme is running. Drum surface and dryer air within is hot. 5.
6 Maintenance and cleaning Service life of product extends and frequently experienced problems will be reduced if it is cleaned at regular intervals. 6.1 Cleaning Lint Filter / Loading Door Inner Surface Lint and fiber released from the laundry to the air during the drying cycle are collected in the Lint Filter. C A C Such fiber and lint are generally formed during wearing and washing. • Clean the entire inner surface of the loading door and loading door gasket with a soft damp cloth.
Maintenance and cleaning A Never use solvents, cleaning agents or similar substances for cleaning due to the risk of fire and explosion! • Drain the water in the tank. • If there is lint accumulation in the funnel of the water tank, clean it under running water. Place the water tank into its seat. • 6.3 Draining the water tank Dampness of the laundry is removed and condensed during drying process and the water that arise accumulates in the water tank. Drain the water tank after each drying cycle.
Maintenance and cleaning • Pull out the filter drawer. • Wash the filter drawer sponge by hand to remove the fiber and lint on the surface. After washing the sponge, squeeze it by hand and remove the excess water. Well-dry the sponge before storing it. C • • • • It is not necessary to clean the sponge if lint and fiber accumulation on it is not significant. • Place the sponge back into its place. • Close the filter drawer as to lock the red button.
Maintenance and cleaning • Close the kick plate cover. A C Drying without the filter drawer sponge in place will damage the machine! A dirty lint filter and filter drawer will cause longer drying periods and higher energy consumption. 6.5 Cleaning the evaporator Clean the lint accumulated on the fins of the evaporator located behind the filter drawer with a vacuum cleaner. A 28 / 32 EN You can also clean by hand provided that you wear protective gloves. Do not attempt to clean with bare hands.
7 Troubleshooting Drying process takes too much time. • Pores of the lint filter are clogged. >>> Wash the lint filter with warm water. • Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer. • Ventilation grids on the front side of the machine are blocked. >>> Remove the objects (if any) that block ventilation in front of the ventilation grids. Ventilation is not sufficient since the room where the machine is installed is very small.
Troubleshooting End symbol is on. • Programme is over. Turn off the dryer and take out the laundry. Lint Filter Cleaning symbol is on. • Lint filter is not cleaned. >>> Clean the lint filter. Lint Filter Cleaning symbol is flashing. • Filter housing is clogged with lints. >>> Clean the lint filter housing. • A deposit has built up on the lint filter pores that may cause clogging. >>> Wash the lint filter with warm water. • Filter drawer is clogged.