User Manual

Instructions for the User

14.2 Replacing the light bulb

To replace the light bulb, proceed as follows:

 Disconnect the oven from the power supply. Take the plug out

of the socket or switch off the oven’s power circuit.

 Unscrew and remove the glass light cover (1).

 Remove the light bulb (2). Warning! The bulb may be very hot.

 Fit a new E14 230-240V/15W bulb. Follow the lamp manufacturer’s

instructions. IMPORTANT NOTE: Make sure that the sealing rings (3)

are applied in the correct sequence.

 Screw the glass light cover into place (1).

 Connect the oven again to the power supply.

15 INSTALLING THE APPLIANCE

15.1 Before installation

Check that the input voltage indicated on the characteristics plate is the

same as the voltage of the power outlet you are going to use.

Open the oven door and take out all the accessories and remove the

packing material.

Warning! The front surface of the oven may be covered in a protective

film. Before using the oven for the first time, carefully remove this film,

starting on the inside.

Make sure that the oven is not damaged in any way. Check that the

oven door closes correctly and that the interior of the door and the front of

the oven opening are not damaged.

DO NOT USE THE OVEN if the power cable or the plug is damaged, if the

oven does not function correctly or if it has been damaged or dropped.

Put the oven on a flat and stable surface. The oven must not be installed

close to any sources of heat, radios or televisions.