Technical data
Table Of Contents
- 1. INSTRUCTIONS FOR USE
- 2. SAFETY PRECAUTIONS
- 3. ENVIRONMENTAL RESPONSIBILITY
- 4. GET TO KNOW YOUR OVEN
- 5. AVAILABLE ACCESSORIES
- 6. FRONT PANEL
- 7. USING THE OVEN
- 7.2.1 Internal oven lights
- 7.2.2 Oven runners
- 7.2.3 Cooling system
- 7.6.1 Cooking with a preset temperature
- 7.6.2 Changing the preset temperature
- 7.7.1 Cooking timed with the timer
- 7.7.2 Semi-automatic cooking
- 7.7.3 Automatic cooking
- 7.7.4 Changing the preset temperature
- 1 P1: OFF / ON Activate or deactivate the child safety lock (); this function, after 2 minutes of operation without any actions by the user, locks all the functions and knobs; it is identified by the appearance of on DSP1. To temporarily deactivate l...
- 2 P2: OFF / ON Activate or deactivate the Show Room function; this function disables all the heating elements so that only the control panel works (to use the oven normally, set P2:OFF).
- 3 P3: OFF / ON Activate or deactivate the function that allows a maximum consumption of 2300 W.
- 7.8.1 Change the settings in the secondary menu
- 8. COOKING WITH THE OVEN
- 9. CLEANING AND MAINTENANCE
- 10. EXTRAORDINARY MAINTENANCE
- 11. INSTALLING THE APPLIANCE
Instructions for the user
64
Modifying the set data
Once automatic cooking has started, its duration can be changed.
When and are steady and cooking is in progress, or the oven is in
standby waiting for cooking to start, press PT1 once. starts flashing and
PT1 can be turned to change the set duration.
Press PT1 again; goes out, starts to flash, and the cooking start time
will be displayed on DSP1. The cooking start time can be increased or
decreased by turning PT1.
A few seconds after the last change, and will appear (in steady mode)
on DSP1 and automatic cooking will restart with the new settings.
Once the desired function has been selected, the oven will begin cooking at the
preset temperature. Cooking is preceded by a pre-heating phase (common to
all functions) which allows the oven to reach the cooking temperature more
quickly.
This phase is indicated by flashing on the display (DSP1). At the end of the
pre-heating phase, will remain constantly on to indicate that the food can
be placed inside the oven.
7.7.4 Changing the preset temperature
The preset temperature for each function can be changed to suit the user's
requirements.
At any time while cooking is in progress, turn PT1 in either direction to increase
or decrease the cooking temperature by 5 degrees at a time. PT1 can also be
held in the left or right position to increase or decrease the setting more quickly.