Technical data

Instructions for the user
78
9.6.2 Setting the automatic cleaning cycle
Use PT2 to select one of the two pyrolysis functions and with the oven
in STAND-BY (see “Selecting functions (pyrolytic models)”).
To start the cleaning (Pyrolysis) cycle, press PT1 once to set its duration ( ).
Turn PT1 to the right or left to increase or decrease the cycle duration between a
minimum of 1h 30m and a maximum of 3h 00m. (Except for the function
where the cycle duration is fixed at 1h 30m.)
The word
PYro will appear on DSP1 to indicate that the oven is carrying out
the cleaning process (in the case of the
function, Peco is displayed on
DSP1). One minute after the cleaning cycle (Pyrolysis) starts, the door lock
device will be tripped, preventing the door from being opened.
lights up on DSP1 to indicate that the door lock device has been activated.
To select a cleaning cycle with delayed start, after setting the duration press
PT1 once. and the current time will appear on the display.
Tur ning PT1 to the right increases the time, allowing the cleaning cycle start
time to be set.
A few seconds after the desired duration is set, and will remain lit, and
the oven will start to wait for the starting time set.
It is not possible to select any functions once the door locking device has been
activated. Wait for to go out.