Food Warmer User Manual

INSTALLATION

4) FIXING

A special sealing strip underneath the hob for

damage. Make sure it is correctly positioned with no

gaps; it avoids any water infiltration. To fix in the right

way the strip, please, respect the following

instructions:

- fix the hooks in the relative accomodations of the

body (see fig. 7).

- Overturn the hob, take the seal strips off from their

support, having care that the transparent protection

remains attached to the seal. Correctly place the

seal "E" (fig.7) under the hob edge, so that the

external side of the seal fits together with the

external perimentrical edge of the hob. The ends of

the strip must fit together without overlapping.

- Stick the seal to the hotplate uniformly, pressing it

with fingers.

- Take the protective paper strip of the seal off, place

the hotplate in the opening made in the table top,

and lock it with the special screws "F" (fig. 8).

- In order to avoid accidental touch with the

overheating bottom of the hob, during the working,

is necessary to put a wooden insert, fixed by

screws, at a minimum distance of 60 mm from the

top (see fig. 5).

WARNINGS:

be aware that the glue that join the laminated

plastic to the furniture, has to resist to

temperature not below 150 °C, to avoid the

unstuck of the panelling.

The rear wall, adjacent and surrounding surfaces

must therefore be able to withstand an

overtemperature of 65K.

FIG. 7 FIG. 8