Operation Manual

Use
33
EN
2.9 Software updates
Appliance connectivity software updates
are occasionally issued.
If the device is connected to the home
WLAN network, updates are detected and
downloaded automatically.
In general, updates are installed
automatically, but in some cases,
confirmation from the user is required.
• Touch the CANCEL button to
cancel the update procedure.
or
• Touch the CONFIRM button to
confirm the update procedure.
At the end of the update procedure, the
following appears on the display:
The appliance can now be used normally.
During the short update procedure
with confirmation from the user, it is
not possible to use the appliance
normally.
The new software version can be
seen in the SmegConnect
menu under Wi Fi FW release.
During installation, the connectivity
service is suspended temporarily (this
lasts for approximately 2 minutes).