Operation Manual

Cleaning and maintenance
83
EN
4.5 Cleaning the oven cavity
Removing racks/trays support frames
Removing the guide frames enables the
sides to be cleaned more easily. This
operation should be performed each time
the automatic cleaning cycle is used (on
some models only).
To remove the guide frames, pull the frame
towards the inside of the oven to unhook it
from its groove A, then slide it out of the
seats at the back B.
When cleaning is complete, repeat the
above procedures to put the guide frames
back in.
Cleaning the top section
The oven cavity is fitted with a tilting heating
element which facilitates cleaning the top
part (roof) of the oven.
1. Delicately push the middle section of the
upper heating element towards the rear
of the oven to release it from the central
bush.
2. Gently lower the heating element until it
stops.
3. When you have finished cleaning, put
the heating element back in position.
Improper use
Risk of damage to the appliance
• Do not excessively flex the element
during cleaning.