User Manual

Cleaning and maintenance
39
EN
4. At the end of the Vapour Clean cycle,
“STOP” flashes on the display and a
buzzer will sound that can be
deactivated by opening the door or
pressing/turning one of the two knobs.
Setting the programmed Vapour Clean
cycle
The Vapour Clean start time can be
programmed just like any other cooking
function.
1. After selecting the Vapour Clean
function, press the programming knob.
The display shows the current time, the
temperature and the indicator light
comes on.
2. Turn the programming knob to set the
time you wish the Vapour Clean cycle
to finish.
3. Press the programming knob to confirm
the parameters entered. The
,
and indicator lights remain lit
steadily and the appliance waits for the
set start time to start the Vapour Clean
cycle.
End of the Vapour Clean cycle
1. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
2. Use a non-scratch sponge with brass
filaments on hard to remove deposits.
3. In case of grease residues use specific
oven cleaning products.
4. Remove any remaining water from
inside the oven cavity.
5. If present, replace the self-cleaning
panels and the rack/tray support
frames.
For improved hygiene and to avoid food
being affected by any unpleasant odours:
• it is recommend that you dry the oven
cavity using a fan-assisted function at
160°C for approximately 10 minutes.
• If fitted with self-cleaning panels, we
recommend that you dry the oven cavity
together with a catalysis cycle (see
“Regeneration of the self-cleaning
panels (catalysis cycle) (on some models
only)”).
We recommend wearing rubber
gloves for these operations.
We recommend removing the
door in order to make the manual
cleaning of the parts that are
difficult to reach easier.