Instruction manual

72 - CLEANING AND MAINTENANCE 914779617/A
3. Select the most appropriate setting for the
automatic cleaning of the oven cavity:
4. Touch the CONFIRM button to confirm
the setting.
The appliance is ready to start the automatic
cleaning cycle.
5. Touch the START button to start the
pyrolytic cycle.
During the pyrolytic function
• It is not possible to select any function once
the door lock device has been activated. It
remains possible, however, to switch off the
appliance using the specific controls.
• the fans produce a more intense level of
noise due to a greater rotation speed. This is
an absolutely normal operation, intended to
provide more effective heat dispersal.
• Two minutes after the pyrolytic cycle has
started, the door is locked by a device that
prevents the door from being opened (the
symbol appears on the display).
End of pyrolytic function
• At the end of pyrolytic cycle, the appliance
emits a short beep.
• The fans will continue to operate for long
enough to avoid overheating the walls of
adjacent units and the front of the oven.
• A message will appear on the display to
indicate that the oven cavity cooling
procedure is in progress.
1. Wait for the oven cavity to cool down.
2. Open the door and collect the residue
deposited inside the oven cavity with a
damp microfibre cloth.
Extraordinary maintenance
Seal maintenance tips
The seal should be soft and elastic.
Recommended pyrolytic cycle duration:
• Light dirt: 2:00
• Moderately dirty: 2:30
• Heavy dirt: 3:00
The PROGRAMMED COOKING
button can be used to set a
function delayed end time.
It is not possible to start the pyrolytic
cycle if the temperature probe is
plugged in.
The appliance will emit an error signal
each time the START button is
pressed.
During the first Pyrolytic cycle,
unpleasant odours may occur due to
the normal evaporation of oily
manufacturing substances. This is an
absolutely normal phenomenon which
disappears after the first pyrolytic cycle.
If the pyrolytic cycle gives unsatisfactory
results at minimum duration, it is
recommended to set a longer time for
subsequent cleaning cycles.
If the pyrolytic cycle gives unsatisfactory
results at minimum duration, it is
recommended to set a longer time for
subsequent cleaning cycles.
The door is locked until the temperature
inside the oven cavity returns to a safe
level.
We recommend wearing rubber gloves
for these operations.
For easier manual cleaning of parts that
are difficult to reach, we recommend
removing the door.