User manual

INSTALLATION - 83914779647/A
e
Cable replacement
1. Unscrew the screws on the rear casing.
2. Lift the rear casing slightly and remove it to
gain access to the terminal board.
3. Replace the cable.
4. Make sure that the cables (for the oven or
any hob) follow the best route in order to
avoid any contact with the appliance.
C = Position of the power cable.
Positioning
Removing the rear hook
Before fitting the appliance, the cable hook on
the rear cover must be removed using a pair of
scissors or a special tool.
Front panel seal
Glue the supplied seal to the rear part of the
front panel to avoid water or other liquids from
leaking in.
Fastening bushings
1. Remove the bushing covers on the front of
the appliance.
2. Mount the appliance into the recess.
3. Secure the appliance to the cabinet using
screws.
4. Cover the bushings with the previously
removed covers.
Appliance overall dimensions (mm)
Power voltage
Danger of electrocution
• Disconnect the mains power supply.
See General safety instructions.